Partner EM-200 Manual de usuario

EM-200
User Manual


i
Copyright
This publication, including all photographs, illustrations and software, is protected under international
copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be
reproduced without written consent of the author.
Disclaimer
The information in this document is subject to change without notice. The manufacturer makes no
representations or warranties with respect to the contents hereof and specifically disclaims any implied
warranties of merchantability or fitness for any particular purpose. The manufacturer reserves the right to
revise this publication and to make changes from time to time in the content hereof without obligation of the
manufacturer to notify any person of such revision or changes.
Trademark recognition
All product names used in this manual are the properties of their respective owners and are acknowledged.
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment onto an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interconnect cables and a shielded AC power cable must be employed with this equipment to
ensure compliance with the pertinent RF emission limits governing this device. Changes or modifications not
expressly approved by the system’s manufacturer could void the user’s authority to operate the equipment.
WARNING
This is a class A product. In a domestic environment this product may
causeradio interference in which case the user may be required to take
adequate measures.
Declaration of conformity
This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

ii
About this manual
This manual is intended for system administrators who are familiar with setting up a new system and
installing an operating system.
The manual consists of the following sections:
Chapter 1 Getting Started: This section covers unpacking and checking the
package contents, identifying components, installing the
battery pack, charging the battery and powering on.
Chapter 2 BIOS Setup Utility: The BIOS chapter provides information on navigating
and changing settings in the BIOS Setup Utility.
Chapter 3 Upgrading Components: This section provides information on upgrading
components.
Appendix: The appendix covers troubleshooting, information
on having the EM-200 serviced, and technical
specications.
Safety information
Before installing and using the EM-200, take note of the following precautions:
• Read all instructions carefully.
• SAR compliance for body-worn operations is restricted which provide at least 2 cm separation between
the device and the user’s body
• Do not place the unit on an unstable surface, cart, or stand.
• Do not block the slots and opening on the unit, which are provided for ventilation.
• Do not push objects in the ventilation slots as they may touch high voltage components and result in
shock and damage to the components.
• Do not place anything on the power cord. Place the power cord where it will not be in the way of foot
traffic.
• Follow all warnings and cautions in this manual and on the unit case.
• When replacing parts, ensure that your service technician uses parts specified by the manufacturer.
• Avoid using the system near water, in direct sunlight, or near a heating device.
• Never throw the battery into a fire or put it near a fire.
WARNING
Warning! Batteries may explode if not handled properly. Do not disas-
semble or dispose of them in re. Keep them away from children. Follow
local regulations when disposing of used batteries.
警告
不正確地更換電池會有爆炸的危險。僅可更換為廠商建議的相同電池或相同型
式電池。請依據廠商說明書棄置電池。
注意
用错误型号电池更换会有爆炸危险务必按照说明处置用完的电池。

iii
Revision history
Version 1.0, August 2009

iv
TABLE OF CONTENTS
CHAPTER 1 GETTING STARTED................................................ 1
Unpacking the machine..................................................................................1
Checking the package contents ....................................................................2
Identifying components .................................................................................3
Installing the battery pack ..............................................................................8
Charging the battery pack..............................................................................9
Powering on .................................................................................................10
CHAPTER 2 BIOS SETUP...........................................................11
About the Setup Utility .................................................................................11
Using the USB keyboard..............................................................................11
Entering the Setup Utility ........................................................................12
BIOS Navigation Keys .............................................................................12
Using BIOS .............................................................................................13
Main Menu ...................................................................................................14
Advanced Menu ...........................................................................................15
► Boot Conguration ..............................................................................16
► IDE Conguration................................................................................17
► Channel 1 Master................................................................................18
Security Menu ..............................................................................................19
Boot Menu....................................................................................................20
►Boot Device Priority..............................................................................21
►Boot Type Order ...................................................................................21
Exit Menu .....................................................................................................22
CHAPTER 3 UPGRADING COMPONENTS............................... 23
Safety and precautions ...............................................................................23
Before you begin..........................................................................................24
Upgrading the hard drive..............................................................................25
Upgrading the memory module....................................................................27
Upgrading the Mini-PCIE card .....................................................................28
APPENDIX .................................................................................. 31
Troubleshooting ...........................................................................................31
Tips for Troubleshooting...............................................................................31
General Problems .......................................................................................32
Having the EM-200 Serviced ......................................................................33
Specication.................................................................................................34

1
CHAPTER 1
GETTING STARTED
This chapter describes the procedures from unpacking the EM-200, to powering it on. The following topics
are described.
• Unpacking the machine on page 1
• Checking the package contents on page 2
• Identifying components on page 3
• Installing the battery pack on page 8
• Charging the battery pack on page 9
• “Powering on” on page 10
Unpacking the machine
The machine and cable accessories are packed in a cardboard carton with foam padding for protection during
shipping.
Figure 1.1 Unpacking the
machine
Carefully unpack the machine and keep the packing materials. If you need to ship it in the future, repack it as
shown in Figure 1.1.

2 CHAPTER 1 GETTING STARTED
Checking the package contents
After you unpack the device, check that the following items are included.
If any item is missing or appears damaged, contact your dealer immediately.
AC adapter
Driver CD with drivers
and the user manual
PDF le.
EM-200
Metal Stylus
Battery
Power cord
Protection pack
Quick Start Guide
QSG

3
Identifying components
This section describes the parts and connectors on the machine.
Front view
1 2 3 4 5 6 7
98
Figure 1.2 Front view
Component Description
1 Power indicator
2 Battery charging indicator
3 HDD status indicator
4 WiFi On/ Off indicator
5 Bluetooth On/ Off indicator
6 3.5G LAN On/Off indicator (optional)
7 Built-in Microphone
8 Camera (optional)
9 10.1-inch touch panel

4 CHAPTER 1 GETTING STARTED
Left view
1
Figure 1.3 Left view
Component Description
1 5-in-1 media card slot
2 Express card 34 slot
3 USB port
4 Power button
5 RJ45 LAN jack
6 DC IN
32 4 5 6
Otros manuales para EM-200
1
Tabla de contenidos
Otros manuales de Tableta de Partner

Partner
Partner OT-100 Manual de usuario

Partner
Partner EM-70B Manual de usuario

Partner
Partner ART101 Manual de usuario

Partner
Partner EM-70 Manual

Partner
Partner OT-100 Manual de usuario

Partner
Partner EM-220 Manual de usuario

Partner
Partner EM-200 Manual de usuario

Partner
Partner PAT-120 Manual de usuario

Partner
Partner EM-100 Manual de usuario

















