Panasonic ET-SFR510 Manual de usuario

Model No. ET-SFR510

Operating Instructions

Smoke Cut Filter Commercial Use

Thank you for purchasing this Panasonic product.

■Carefully read through these operating Instructions and the operating instructions of the

projector to ensure safe and proper operation.

■Please save this manual for future use.

ÚAll the projector illustrations in this manual are based on PT-DZ21K model.

Attention

●Do not reuse it. The smoke cut lter to be replaced should be an unused product.

●Do not wash the smoke cut lter with water.

●Please switch the lter type settings of the projector when using this smoke cut lter.

Note

●When the lter type is set to [SPECIAL], the fan speed increases and “U75” appears on the

self-diagnosis display on the side of the projector.

●This lter can be used for approximately 24 hours in smoky environments.

If it is used for more than approximately 24 hours, operating problems may occur and

inspection or repairs might be required.

●Do not use the lter at high altitudes (1 400 m above sea level) or in places where the ambient

temperature is 35°C or higher.

Self-diagnosis

display

TQZJ432-2

2 - ENGLISH

Attention

●Turn the main power o󰀨 before replacing the smoke cut lter.

●Make sure that the projector is stable when attaching the smoke cut lter, and work in an

environment that is safe, even in the event of the smoke cut lter dropping.

Installing the smoke filter

1) Turn o󰀨 the projector and disconnect the power plug from the wall outlet.

●When the power is to be turned o󰀨, be absolutely sure to follow the procedure described

in “Switching o󰀨 the projector” in the operating instructions of the projector.

2) Remove the air lter cover.

●

Remove the air lter cover by turning

the air lter cover xing screw

counterclockwise using the Phillips head

screwdriver until it turns freely.

3) Remove the air lter unit.

●While gently pressing the area near

the center of the frame on the lens side

(front side) of the air lter unit toward

the inside as shown by the arrow,

disengage the frame from the projector

tabs, and draw it out. Then disengage

the frame on the other side from the

tabs, and take out the unit.

●After taking o󰀨 the air lter unit, remove

any accumulations of dust and dirt on

the area of the projector where the air

lter unit is stowed and on the air intake

of the projector.

Attention

●Take care not to touch the radiator ns or

other parts when removing the dirt and

dust.

Air lter cover

Air lter cover xing screw

Air lter unit

Area where the air lter unit is stowed

and

air intake of the projector

Projector tabs

ENGLISH - 3

Installing the smoke filter (Continued)

4) Attach the smoke cut lter to the

projector.

●

Catch the smoke cut lter onto the

two tabs on the back of the area of

the projector where the air lter unit is

stowed (area where the smoke cut lter

is stowed), and install the lter following

the instructions in step 3) in reverse.

• There is no di󰀨erence between the top

and bottom, or front and back, of the

smoke cut lter.

• Check that the smoke cut lter has

latched onto the tabs in the area of

the projector where the air lter unit

is stowed (area where the smoke cut

lter is stowed).

●For the steps to take when changing

back to the air lter unit, refer to the

operating instructions of the projector.

5) Install the air lter cover on the projector and use a Phillips screwdriver to

tighten the air lter cover xing screw.

●Insert the air lter cover by following the instructions for step 2) in the reverse order.

Attention

●Be sure to install the air lter unit or smoke cut lter before turning on the projector. Using the

projector without the air lter unit or smoke cut lter will cause dirt and dust to accumulate

inside the projector and could result in malfunction.

• When the projector is used without the air lter unit installed, a message is displayed for

about 30 seconds on the projection screen.

• When using the projector with the smoke cut lter installed, a message is displayed for

about 30 seconds on the projection screen every time the power is turned on.

●Dispose of the packaging materials properly after taking the product out of it.

Smoke cut lter

Area where the air lter unit is stowed

(Area where the smoke cut lter is stowed)

Changing the filter mode settings

1) After installing the smoke cut lter, turn on the

projector and press <MENU> button. Select

[PROJECTOR SETUP] from the [MAIN MENU] and

press <ENTER> button.

ENTER

MAIN MENU

PICTURE

POSITION

ADVANCED MENU

DISPLAY LANGUAGE

3D SETTINGS

DISPLAY OPTION

PROJECTOR SETUP

P IN P

TEST PATTERN

SIGNAL LIST

SECURITY

NETWORK

MENU SELECT

SUB MENU

2) Select [SERVICE PASSWORD] in [PROJECTOR

SETUP] Menu and press <ENTER> button.

3) Enter “1111” by pressing <1> on the remote control

and then press <ENTER> button in the service

password entry screen.

4) Press tu to switch from [NORMAL] to [SPECIAL]

in the [AIR FILTER] screen.

AIR FILTER

FILTER TYPE

CHANGE

SPECIAL

Note

●The message [CHECK THE FILTER.] will appear to conrm whether the air lter unit is

switched to the smoke cut lter.

Attention

●After replacing the smoke cut lter with the air lter unit, re-set [FILTER TYPE] to [NORMAL],

and check that “U75” is cleared from the self-diagnosis display on the side of the projector.

Operation problems might occur if the lter settings are not changed.

5) Press <MENU> button to escape from the Menu.

Disposal

When discarding this product, please contact your local authorities or dealer and ask for the

correct method of disposal.

Panasonic Connect Co., Ltd.

Web Site : https://panasonic.net/cns/projector/

SS0412AM2042 -PS

Printed in Japan

Otros manuales de Sistema de filtración de agua de Panasonic

Panasonic

Panasonic ET-RFV200C Manual de usuario

Panasonic

Panasonic TK-CJ21 Manual de usuario

Panasonic

Panasonic ET-RFM100 Manual de usuario

Panasonic

Panasonic ET-EMF320C Manual de usuario

Panasonic

Panasonic ET-RFE300C Manual de usuario

Panasonic

Panasonic ET-EMF300 Manual de usuario

Panasonic

Panasonic TK-CS10 Manual de usuario

Panasonic

Panasonic ET-RFV200 Manual de usuario

Panasonic

Panasonic ET-RFV300 Manual de usuario

Panasonic

Panasonic ET-ACF100 Guía

Panasonic

Panasonic TK-AS45 Manual de usuario

Panasonic

Panasonic MicroClear TK-CS200 Manual de usuario

Panasonic

Panasonic TK7585-SHK Manual de usuario

Panasonic

Panasonic ET-EMF510 Manual de usuario

Panasonic

Panasonic ET-RFV100 Manual de usuario

Panasonic

Panasonic ET-RFL300 Manual de usuario

Panasonic

Panasonic TK-AS40 Manual de usuario

Panasonic

Panasonic ET-RFC100 Manual de usuario

Panasonic

Panasonic ET-EMF100 Manual de usuario

Panasonic

Panasonic Noise Filter Array Manual de usuario

Panasonic

Panasonic TK6305P Manual de usuario

Panasonic

Panasonic TK-CB430 Manual de usuario

Panasonic

Panasonic ET-RFF200 Manual de usuario

Panasonic

Panasonic TK-CJ300-WTH Manual de usuario

Manuales populares de Sistema de filtración de agua de otras marcas

Wisy

Wisy LineAir 100 Manual de usuario

Schaffner

Schaffner Ecosine FN3446 Series Manual de funcionamiento

Pentair

Pentair FLECK 4600 SXT Guía del usuario

H2O International

H2O International H20-500 Manual de usuario

Renkforce

Renkforce 2306241 Manual de usuario

Neo-Pure

Neo-Pure TL3-A502 Manual de usuario

FLTR

FLTR OBF Manual de usuario

STA-RITE

STA-RITE VERTICAL GRID DE FILTERS S7D75 Manual de usuario

Applied Membranes

Applied Membranes W-G844EM Manual de usuario

BEGA

BEGA 116 Manual de usuario

WATA

WATA Standard Manual de usuario

Price

Price FFU series Manual

Gaggenau

Gaggenau BRITA INTENZA 467873 Manual de usuario

Brita

Brita SAFF-100 Manual de usuario

HEISSNER

HEISSNER FPU24000-00 Manual de usuario

BGS technic

BGS technic 1518 Manual de usuario

Reverse Osmosis

Reverse Osmosis RF Series Manual de usuario

ubbink

ubbink Filtramax Series Manual de usuario