Panasonic PT52LCX16 - MULTI MEDIA DISPLAY Manual de usuario

LCX16 / LCX66 Series Projection LCD TV

Tuner Firmware Installation Instructions

Table of Contents

Table of Contents ..............................................................................................1

1Firmware History.............................................................................................. 2

1.1 Applicable Models ........................................................................................ 2

1.2 Firmware Version......................................................................................... 2

1.3 Release Date............................................................................................... 2

1.4 Purpose...................................................................................................... 2

2Check Firmware Version................................................................................... 3

3Download Firmware ......................................................................................... 4

4Format SD Card ................................................................................................ 5

4.1 Using SD Formatter Software ........................................................................ 5

4.2 Using the Windows XP Format Option ............................................................. 7

5Copy Firmware to SD Card................................................................................ 9

5.1 Using SEND TO............................................................................................ 9

5.2 Using COPY & PASTE.................................................................................... 9

5.3 Using DRAG & DROP ...................................................................................10

6Install Firmware..............................................................................................11

LCX16 / LCX66 Series Projection LCD TV Tuner Firmware Installation Instructions

Page 1 of 11

1Firmware History

1.1 Applicable Models

PT-52LCX16, PT-52LCX66, PT-56LCX16, PT-56LCX66, PT-61LCX16, PT-61LCX66

1.2 Firmware Version

1.43

1.3 Release Date

5 July 2006

1.4 Purpose

•Corrects Macroblock noise with Sencore generator HDTV996.

•Corrects over-the-air (OTA) ATSC channels dropping off the channel list and "Channel

Not Available" from being displayed.

•Corrects "Poor Signal Quality" from being displayed after a digital over-the-air (OTA)

ATSC or cable (without using CableCARD) channel is lost.

LCX16 / LCX66 Series Projection LCD TV Tuner Firmware Installation Instructions

Page 2 of 11

2Check Firmware Version

1) Power the TV ON.

2) Press the [MENU] button on the TV remote.

3) Scroll down to SETUP and then press [OK].

4) Scroll down below CC to ABOUT and then press [OK].

5) Scroll up or down to VERSION and then press [OK].

The below indicates how to

read the firmware version, not

which firmware version will be

displayed.

NOTE: The below screen will be displayed.

Tuner Firmware Version: 1.78

Starting with the 2nd to last number, read every other number right

to left.

EEPROM Firmware Version: 1.46

Starting with the second number, read every other number left to

right.

LCX16 / LCX66 Series Projection LCD TV Tuner Firmware Installation Instructions

Page 3 of 11

3Download Firmware

1) Left click on the DOWNLOAD icon for the LCX16 / LCX66 Series Projection LCD TV Tuner

firmware.

- LCX16 / LCX66 Series Projection LCD TV Tuner Firmware Update

2) Left click on SAVE.

The file name displayed should be

SDDL.SEC.

3) Left click on DESKTOP, and then left click on SAVE.

NOTE: The SDDL.SEC file will be placed on the DESKTOP.

LCX16 / LCX66 Series Projection LCD TV Tuner Firmware Installation Instructions

Page 4 of 11

4Format SD Card

Use one of the below methods to format an SD Card.

CAUTION: Formatting irretrievably deletes all the data on the SD Card, including

any protected content. Check the SD Card carefully to verify there are not any

files which should not be deleted before proceeding with formatting the SD Card.

4.1 Using SD Formatter Software

NOTE: The SD Formatter software can be downloaded from the Panasonic USA

support site.

1) Insert an SD Card into the SD Card Slot built-in to the computer or into an SD Card

Reader/Writer attached to the computer.

NOTE: If the below screen appears after inserting the SD Card into the SD Card

Reader/Writer or SD Card Slot, left click on CANCEL.

2) Click on START, mouse over ALL PROGRAMS, mouse over PANASONIC, mouse over

SDFORMATTER, and then left click on SDFORMATTER.

3) Select the drive designated as the SD Card Drive from the drop down list, and then left

click on FORMAT.

NOTE: The version of SD

Formatter displayed in ALL

PROGRAMS will be

dependent upon the version

downloaded and installed.

LCX16 / LCX66 Series Projection LCD TV Tuner Firmware Installation Instructions

Page 5 of 11

CAUTIONS:

•Do NOT remove the SD Card from the SD Card Slot or SD Card Reader/Writer

during the formatting process.

•Do NOT disconnect the SD Card Reader/Writer from the computer during the

formatting process.

4) Left click on OK.

NOTE: During the formatting process, the below screen will be displayed.

5) Left click on OK.

6) Left click on EXIT.

LCX16 / LCX66 Series Projection LCD TV Tuner Firmware Installation Instructions

Page 6 of 11

4.2 Using the Windows XP Format Option

1) Insert an SD Card into the SD Card Slot built-in to the computer or into an SD Card

Reader/Writer attached to the computer.

NOTE: If the below screen appears after inserting the SD Card into the SD Card

Reader/Writer or SD Card Slot, left click on CANCEL.

2) Double click on the MY COMPUTER icon on the DESKTOP.

3) Right click on SECURE DIGITAL STORAGE DEVICE (the SD Card Reader/Writer Drive),

and then left click on FORMAT.

4) Ensure FAT is selected under FILE SYSTEM, and then left click on START.

LCX16 / LCX66 Series Projection LCD TV Tuner Firmware Installation Instructions

Page 7 of 11

5) Left click on OK.

6) After formatting is complete, left click on OK.

7) Left click on CLOSE.

LCX16 / LCX66 Series Projection LCD TV Tuner Firmware Installation Instructions

Page 8 of 11

5Copy Firmware to SD Card

5.1 Using SEND TO

1) Insert the formatted SD Card into the SD Card Slot or SD Card Reader/Writer, if the SD

Card has been removed.

2) Right click on the SDDL.SEC icon on the DESKTOP, mouse over SEND TO, and then

left click on SECURE DIGITAL STORAGE DEVICE (the drive designated as the SD Card

Drive).

NOTE: The below window will be displayed during the copying process.

5.2 Using COPY & PASTE

1) Insert the SD Card formatted using the SD Formatter software into the SD Card Slot or

USB Reader/Writer, if the SD Card has been removed.

2) Right click on the SDDL.SEC icon on the DESKTOP and then left click on COPY.

3) Double click on the MY COMPUTER icon on the DESKTOP.

LCX16 / LCX66 Series Projection LCD TV Tuner Firmware Installation Instructions

Page 9 of 11

4) Right click on the SD Card Drive, and then left click on PASTE.

5.3 Using DRAG & DROP

If an icon for the SD Storage Device has been placed on the DESKTOP, the following

procedure can be used to copy the firmware file to the SD Card.

1) Insert the SD Card formatted using the SD Formatter software into the SD Card Slot or

USB Reader/Writer, if the SD Card has been removed.

2) Left click on the SDDL.SEC icon on the DESKTOP, hold down the left mouse button,

and drag the file to the SD CARD DRIVE icon on the DESKTOP.

LCX16 / LCX66 Series Projection LCD TV Tuner Firmware Installation Instructions

Page 10 of 11

Este manual sirve para los siguientes modelos

Tabla de contenidos

Manuales populares de Sistema de proyección de otras marcas

Barco

Barco r9002351 Manual de usuario