PAJ GPS POWER Finder Manual de usuario
USER MANUAL
POWER FINDER WITH ONLINE-TRACKING
Thank you for purchasing our FINDER.
Before first use: Read the instructions
carefully it will introduce you to the
handling and operation of the product.
Please keep the manual for future
reference.
POWER Finder by PAJ with Online localization V.1.0 EN
© PAJ UG (haftungsbeschränkt)
2
Table of contents
1Content of delivery........................... 3
2Product graphics ............................. 4
3Starting up ....................................... 5
3.1 Loading...............................................5
3.2 Activation ...........................................6
3.3 Turning on...........................................7
3.4 Use......................................................8
3.5 Meaning LED lights ............................9
4Technical data ............................... 11
5Safety ............................................ 12
6Notes for the disposal of waste
batteries ........................................ 20
7Note on the disposal of electric
appliances ..................................... 23
POWER Finder by PAJ with Online localization V.1.0 EN
© PAJ UG (haftungsbeschränkt)
3
1CONTENT OF DELIVERY
Delivery contains:
POWER Finder by PAJ
M2M-SIM-card
USB charging cable
USB wall plug adapter
Note: The latest version of this guide can
be found on:
www.paj-gps.de/finder
The team of PAJ-GPS wishes you lots of
fun with your POWER Finder!
POWER Finder by PAJ with Online localization V.1.0 EN
© PAJ UG (haftungsbeschränkt)
4
2PRODUCT GRAPHICS
turning on/off
left = off
right = on
Battery terminal
SIM card tray
LED signal
POWER Finder by PAJ with Online localization V.1.0 EN
© PAJ UG (haftungsbeschränkt)
5
3STARTING UP
3.1 Loading
Before first using, the GPS Tracker should
be charged for approx. 8-12 hours. Connect
the supplied charging cable to the charging
port of the GPS tracker. Then attach the USB
port to the socket adapter. If the GPS tracker
is connected to the power source, charge it
until the red LED turns off.
The POWER Finder offers you a running
time of approx. 40 days without charging!
However, it should be noted that the
duration depends on the load. The more
PAJ's POWER finder is moved and the
more alerts are sent, the higher the
utilization.
POWER Finder by PAJ with Online localization V.1.0 EN
© PAJ UG (haftungsbeschränkt)
6
3.2 Activation
To use the POWER Finder by PAJ it must be
activated online first.
Please go to
start.finder-portal.com
and follow the instructions.
POWER Finder by PAJ with Online localization V.1.0 EN
© PAJ UG (haftungsbeschränkt)
7
3.3 Turning on
If the activation was successful, you can
turn on the POWER Finder by pushing the
switch behind the protective rubber to the
right. Subsequently, the LED lights are
activated. As soon as you have got a GPS
reception, the blue LED flashes.
Recommended first step: To receive the
best GPS signal place the POWER Finder
outside and make sure it is not covered.
Avoid garages, basements and similar.
POWER Finder by PAJ with Online localization V.1.0 EN
© PAJ UG (haftungsbeschränkt)
8
3.4 Use
Once successful, you can place the FINDER
in a location of your choice and take a look
at the FINDER´s location by using a
smartphone, tablet or PC. Use our app or go
to the following website:
www.finder-portal.com
The FINDER-portal will introduce
you to its functions step by step.
POWER Finder by PAJ with Online localization V.1.0 EN
© PAJ UG (haftungsbeschränkt)
9
3.5 Meaning LED lights
Green LED - GPRS status
SIGNAL
MEANING
The green LED is
off
Standby mode
The green LED
flashes every 2-3
seconds
GPRS module available
Blue LED - GPS status
SIGNAL
MEANING
The blue LED
flashes every 2-3
seconds
GPS module available
The blue LED is off
Standby mode
The GPS tracker will go
into standby mode
after not being moved
for a while. You can
activate the tracker by
POWER Finder by PAJ with Online localization V.1.0 EN
© PAJ UG (haftungsbeschränkt)
10
either moving it or
calling the device. The
GPS Tracker will
automatically switch
back on.
The blue LED lights
constantly up
No signal available.
GPS tracker is
searching for a signal.
Red LED - Battery status
SIGNAL
BEDEUTUNG
The red LED
flashes every 2-3
seconds
Battery low
The red LED is off
Battery is fully charged
or battery level is not
empty
The red LED lights
constantly up
GPS-Tracker loading
Otros manuales para POWER Finder
2
Tabla de contenidos
Otros manuales de Accesorios para cámaras de PAJ GPS
