Before Assembly
Cleanliness is paramount. Ensure that you wash your hands or wear
rubber gloves before commencing. Carefully unpack the box and
familiarise yourself with all the components. Carefully clean the glass
bowls. Ensure there are no shards of glass.
Choose the location for the housing
Choose a cool, dry location with a flat and steady surface. Please note
that if the system is in direct sunlight, this can cause the water to receive
lovely energy from the sun, but if left for a long time will make the water
go bad!
Installation Step 1: Install the Tap
From the outside, insert the tap thread through the hole in the lower reser-
voir. From the inside of the reservoir; Place the second silicon gasket over
the thread, remove the protective film from the stainless steel washer before
placing this over the thread and ensure it is correctly seated.
Using your fingers, tighten the nut onto the thread, ensuring the tap is cor-
rectly orientated. Holding the tap in place, tighten the in inside until the sili-
con gaskets match the shape of the reservoir inside and out. Do not
over-tighten beyond this point. Usually it is not necessary to use a spanner
to make the nut really tight. Most people can do it by hand.
Unscrew the nut from the stain-
less steel tap. Remove the protec-
tive film (if applicable) from the
outer stainless steel washer and
place it onto the tap thread.
Ensure the concave shape is ori-
entated to match the silicone
grommet that is to be fitted next.
Place a silicon gaskets onto the
tap thread and push down to rest
against the washer.
