3
User Guide - Orzly SD10 Bluetooth Stereo Headset
Ending A Call
Refusing A Call
Redial The Last Dialled Number
Adjusting The Volume
Play/Pause The Music
Previous/Next Song
Switching The Call Between Mobile And Headset
Troubleshooting
Use either of the following methods to end a call.
Method-1: Press the multifunction button once to end a call from the headset.
Method-2: End a call from the mobile phone’s keypad.
While on a call, the headset will switch the connection from the music player (A2DP) to the mobile phone (HSP
or HFP); and the streaming music will be paused. Aer you have ended the call, the music will start again from
where it was last paused.
When there is an incoming call, press and hold the multifunction button for about 2 seconds until you hear a
tone from the headset and the call will be rejected.
Press and hold down the multifunction button for about 2 seconds to redial the last dialled number.
In call mode or music mode, press volume +/- button to adjust the volume. One short press will adjust one
level. When the headset reaches maximum or minimum volume, an indication tone will sound.
In the idle state, press the multifunction button once to play or pause the music.
When music is playing, press the “forward” button to play the next song and the “backward” button to play the
previous song.
While on a call, press and hold the multifunction button for about 2 seconds until there is a prompt from the
headset. The call will then be switched from headset to your device
or vice versa.
If disconnection occurs, please check the following factors:
1) Ensure that the headset has enough power, is turned on and has been successfully paired to your device.
2) The Bluetooth function of your device is enabled.
3) Check whether the range between the headset and your device is no more than 10 metres (about 30 feet.)
Also check if there is a wall, other disturbances or electrical devices between the headset and your device.
Note: When you press the multifunction button to answer or end a call, please press once. Do not press and hold.
