Omega ORC93XA Guía de instalación

Instructions for the Use and Care and Installation of

ORC93XA

ORC94XBA

Wall

Canopy

Rangehoods

CONTENTS

Warning

Features

Installation

Notice of installation

Safety Warning

Use Instructions

Maintenance

Troubleshooting

Specification

It is important that you retain these instructions, proof of purchase as

well as other important documents about this product for future

reference.

Due to continual product development, Omega reserves the rightto

alter specifications or appearances without notice.

Dispose of packaging responsibly – recycle where facilities are

available.

(1)

Warning

•

Young children should be supervised to ensure that they do not play

with the appliance.

•

The appliance is not intended for use by persons (including children)

with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervised

or instructionconcerning use of the appliance by a responsible person

for their safely.

•

Your cooker hood is for domestic use only, not suitable for barbecue,

fast - food shops, and other commercial use.

•

Any installation work must be carried out by a qualified

electrician or competent person.

•

The cooker hood and its filter mesh should be cleaned regularly in

order to keep in good working order.

•

Before cleaning, always ensure that you have switched your cooker hood

off.

•

Do not flambé under the range hood.

•

Clean the cooker hood according to the instruction manual, and

keep the cooker hood away from the danger of flames.

•

If there is any fault with your cooker hood, please call the customer

service number in the Warranty Card.

•

Please keep the room adequately ventilated when your cooker hood and

gas hob are working.

•

Do not exhaust the gas from cooker hood through the same

heated flue which is for the gas from gas hob and other kitchen

appliances.

•

Before installation and usage, read all the instructions and make sure

that the voltage (V) and the frequency (Hz) indicated on your cooker

hood are exactly the same as the voltage (V) and the frequency (Hz) in

your home. To ensure that you get the best Warranty experience for

your cooker hood, please provide copies of the Warranty Card and

purchase receipt, when booking warranty work with the Customer

Service department

(2)

FEATURES

1. The cooker hood uses high quality materials, and is made with a

streamlined design.

2. Equipped with a high power electric motor and centrifugal fan, it

produces strong suction with low noise, and features a non-stick

grease filter which is easy to clean.

3. The isolated low voltage (12 volt) circuit board control, means the

halogen lights are brighter and safer than incandescent alternatives.

4. Due to the special wind tunnel construction and filter design, any

odours and dust will be absorbed quickly.

(3)

INSTALLATION

3.1 The cooker hood should be

placed at a distance of 65-75cm

(26-30inch) from the cooking surface

for the best effect. See Pic 1.

3.2 Install the hook in a suitable place

once the installation height is fixed,

and keep it vertically aligned. The

fixed position of the inside chimney

bracket determines the location of

the chimney.

3.3 Fix the outside chimney bracket

on the outside chimney, and be sure

that the inside chimney can be

adjusted in height

freely, as well as being able to fix the exhaust pipe (Not included

in the rangehood) . Afterwards, install the exhaust pipe and

chimney on the cooker hood. See Pic 3.

3.4 Lift the cooker hood onto the hook. See Pic 4.

3.5 Adjust the height of the inside chimney to the position of the

inside chimney bracket, and fix by screw. After adjusting the

position, fix the body with safety screws. See Pic 5.

Note: The two safety screw holes are positioned on the back

casing, with diameter of 6m.

Warning: Failure to install the screws or fixing device in accordance with

these

instructions may result in electrical hazards

(4) NOTICE OF INSTALLATION

1. Before installation, please ensure the area is clean, to avoid

suction of the remaining bits of broken wood and dust.

2. The canopy hood cannot share the same air ventilation ducting as

other appliances, such as gas and electric heaters.

3. The bending of the ventilation ducting should be ≥ 120°, parallel or

above the exit vent, and should be connected through the external

wall.

4. After installation, make sure that the extractor is level to avoid

grease collection at one end.

NOTE: Remove all protective plastic coatings from the stainless steel

surfaces before use.

(6)

USE INSTRUCTIONS

The re-usable aluminium grease filters supplied with this rangehood should

be cleaned every month or so to avoid grease build-up.

To remove the grease filter, release the locking mechanism at the front of

the filter, and lower the filter slightly to unhook it at the back.

Whilst the filter is removed, clean off any residual grease from the housing

to avoid fire risk.

When replacing the grease filters, ensure that the locking mechanism is

facing down.

ORC93XA

The range hood has indication diagrams to allow you to easily select the

fan operating speed required.

Push the low button, indicated by a fan with 3 blades, and the motor will

run at a low speed.

Push the medium button, indicated by a fan with 4 blades and the

motor will run at a medium speed.

Push the high button, indicated by a fan with 5 blades and the motor will

run at a high speed.

Push stop button, indicated by an (O) and the motor will stop.

Push the light button, indicated by a lit globe and the two lights will

come on. Push it again and the light will turn off.

ORC94XBA

The ORC94XBA has a touch control panel.

When the power is connected and switched on you will hear a beep

and the display screen will be backlit for 30 seconds and the

rangehood will go into standby mode.

SETTING THE TIME (24 hour time)

In standby mode hold down the Timer button (2-3 seconds) until the

Hour symbol on the display screen starts to flash.

Touch the Add/ON ( ) or Dec/OFF (-) buttons to adjust the hour.

Touch the Timer button once the hours have been set this will allow

you to adjust the minutes by touching the Add/ON ( ) or Dec/OFF (-)

buttons.

ADJUSTING THE MOTOR SPEED

Touch the Add/ON button ( ) and the motor will run at low speed and

the display screen will show .

Touch the Add/ON button ( ) again and the motor will run at medium

speed and the display screen will show .

Touch the Add/ON button ( ) a third time and the motor will run at high

speed and the display screen will show .

You are able to decrease the motor speed by touching the Dec/OFF

button (

). Keep touching the Dec/OFF (

) button until all the bars

disappear and the motor will stop and the rangehood will go into

standby mode.

LIGHT

The lights work independently of the other functions. Push the light

button and the two lighting lamps will come on the display screen

will also show a light symbol. Push it again and the lamps will turn off.

TIMER

The timer can be used to turn off the rangehood automatically after a

period of time (5, 15 and 30 minutes).

Note: The timer does not affect the lamps.

While the rangehood motor is running in any speed press the Timer

button and the display screen will show , press the Timer

button again and the display will show , press the Timer button

again and the display will show . If the Timer button is pressed

again the display will go back to show .

(7)

MAINTENANCE

7.1 Cleaning the grease filter mesh

The filter mesh is made of high-density stainless steel. Please do not use

corrosive detergent on it. Keeping this filter clean will keep the appliance

running correctly. Please strictly follow the guidelines below.

Method 1: Place the mesh in 40 - 50℃ clean water, add in a small

amount of detergent, and soak for 2 - 3 minutes. Wear gloves, and

clean with a soft brush. Do not apply too much pressure, as the mesh is

delicate and will damage easily.

Method 2: The grease filters can be put into a dishwasher. To do so,set

the temperature at around 60℃.

7.2

Notice of cleaning cooker hood

A. To protect the main body from corrosion over a long period of

time, the cooker hood should be cleaned with hot water plus

non-corrosive detergent every two months.

B. Please do not use abrasive detergent for it will damage the

body.

C. Keep the motor and other spare parts free from water, as this

will cause damage to the appliance.

D. Before cleaning the appliance please remember to turn off

power

E. If fitted with active charcoal filters, the charcoal filter should not

be exposed to heat.

F. Please do not tear open the fixed bar around the active charcoal

filter.

G. If the supply cord is damaged, it must be replaced by the

manufacturer or its service agent or a similarly qualified person in

order to avoid a hazard.

Otros manuales para ORC93XA

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Campana de ventilación de Omega

Omega

Omega ORC916MB Manual de usuario

Omega

Omega ORU52X Guía de instalación

Omega

Omega Metal Liner and Decorative Wood Hood Manual de usuario

Omega

Omega ORU50X Guía de instalación

Omega

Omega OBC60BX Manual de usuario

Omega

Omega ORU52XL Manual de usuario

Omega

Omega ORT61X Manual de usuario

Omega

Omega ORF90XL Guía de instalación

Omega

Omega ORU50XL Manual de usuario

Omega

Omega ORU50PX Guía de instalación

Omega

Omega ORC97G Manual de usuario

Omega

Omega OTEC IEMP-D Series Manual de usuario

Omega

Omega ORT6WXA Guía de instalación

Omega

Omega ORU52XL Manual de usuario

Omega

Omega K224 Manual de usuario

Omega

Omega ORU52GLED Manual de usuario

Omega

Omega ORU70MB Manual de usuario

Omega

Omega ORU52MB Manual de usuario

Omega

Omega ORC60MB Manual de usuario

Omega

Omega ORU52XL Manual de usuario

Omega

Omega ORF60XL Manual de usuario

Omega

Omega ORS6WXA Guía de instalación

Omega

Omega K181V90 Manual de usuario

Omega

Omega ORU90XL Manual de usuario

Manuales populares de Campana de ventilación de otras marcas

emmeti

emmeti RECUPA MED A-140 Guía

Nibe

Nibe F135 Manual de usuario

Kuppersberg

Kuppersberg INTRO 60 Instrucciones de instalación y mantenimiento

Zephyr

Zephyr Spruce AK9834BS Guía de instalación

Hisense

Hisense MH6INBG Manual de usuario

Miele

Miele DA 1255 Manual de usuario

Broan

Broan 46000 Manual de usuario

GE Profile PV977 Instrucciones originales

FALMEC

FALMEC FFRIA24W5FS Manual de usuario

Whirlpool

Whirlpool RH2600XL-1 SERIES Manual de usuario

Küppersbusch

Küppersbusch DX ISLA Manual de usuario

ETNA

ETNA AV360RVS Manual de usuario

JUNO

JUNO JDF603E6 Manual de usuario

Miele

Miele DA 6708 D Manual de usuario

Tricity Bendix

Tricity Bendix LE 150 Manual

AEG

AEG X68163BV1 Manual de usuario

AEG

AEG 125 D Manual de usuario

Smeg

Smeg KSEV97X Manual de usuario