Ocean Insight FLAME Manual de usuario
FLAME
Scientific-Grade Spectrometer
Installation and Operation Manual
For Products: FLAME-S, FLAME-T
MNL-1012 Rev A
i
MNL-1012 Rev A
i
Table of Contents
About This Manual........................................... ii
Warnings & Cautions ....................................................................ii
Warranty .......................................................................................iv
Certifications and Compliance ...................................................iv
Introduction..................................................... 1
Product Description..................................................................... 1
Features........................................................................................ 1
Items Included With Shipment.................................................... 1
Installation and Setup ...................................... 2
Software Installation ................................................................... 2
Hardware Setup ........................................................................... 3
Troubleshooting .............................................. 7
Frequently Asked Questions ....................................................... 7
Repairs........................................................................................ 10
Servicing ..................................................................................... 10
Technical Specifications ................................ 11
Electrical Pinout ......................................................................... 14
Timing Signals............................................................................ 17
External Triggering..................................................................... 18
Calibration ..................................................... 21
Wavelength Calibration.............................................................. 21
Irradiance Calibrations .............................................................. 21
Copyright © 2020 Ocean Insight
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, by any means, electronic, mechanical, photocopying,
recording, or otherwise, without written permission from Ocean Insight.
This manual is sold as part of an order and subject to the condition that it shall not, by way of trade or otherwise, be lent, re-sold, hired out or otherwise circulated
without the prior consent of Ocean Insight, Inc. in any form of binding or cover other than that in which it is published.
Trademarks
All products and services herein are the trademarks, service marks, registered trademarks or registered service marks of their respective owners.
Limit of Liability
Every effort has been made to make this manual as complete and as accurate as possible, but no warranty or fitness is implied. The information provided is on an
“as is” basis. Ocean Insight shall have neither liability nor responsibility to any person or entity with respect to any loss or damages arising from the information
contained in this document.
MNL-1012 Rev A
ii
About This Manual
Warnings & Cautions
This device may cause radio interference or may disrupt the operation of nearby equipment. It may be necessary to take
mitigation measures such as re-orienting, relocating or shielding the location.
Caution: Do not let contaminants get into the bench. Keep the protective cap on the slit aperture when not connected to an
accessory, probe or fiber.
Caution: Only change the slit aperture in a clean environment where contaminants including dust cannot enter the bench during the
procedure.
Caution: Substitution of a component or accessory different from that supplied may result in measurement error, equipment
damage, increased emissions or decreased immunity.
Caution: Repairs should be undertaken only by personnel trained or authorized by Ocean Insight. The device does not contain any
user serviceable parts.
Caution: Do not immerse the device in any fluid, place fluids on top of or attempt to clean with liquid detergents or cleaning agents.
This may cause an electrical hazard. Do not use if accidental wetting occurs.
MNL-1012 Rev A
iii
Caution: Do not remove any covers. Doing so may increase the risk of electrical shock or compromise the integrity of the optical
components.
Caution: Do not gas sterilize or autoclave this device.
Caution: Consult local codes and ordinances for proper disposal of equipment and other consumable goods.
Caution: The device and/or accessories may not operate correctly if used or stored outside the relevant temperature and humidity
ranges described in the Technical Specifications.
Caution: Do not use if device is dropped and/or damaged. Have an authorized service representative check the device before using
again.
Caution: Be sure to install any software BEFORE connecting the spectrometer to your PC or host system. The software installs the
drivers required for spectrometer installation. If you do not install the software first, the system may not properly recognize
the spectrometer.
Caution: To ensure reliable operation, it is recommended that the power supply be attached prior to inserting the USB connector.
Caution: The user of this spectrometer shall have the sole responsibility for any malfunction which results from improper use, faulty
maintenance, improper repair, damage or alteration by anyone other than Ocean Insight or their authorized service
personnel.
MNL-1012 Rev A
iv
Warranty
For the most current warranty information, please visit OceanInsight.com.
Certifications and Compliance
This is an FCC Class A product. In a domestic environment, this product may cause radio
interference in which case the user may be required to take adequate measures.
Warning
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which the user will be required to correct the interference at his own
expense.
MNL-1012 Rev A
v
RoHS-Compliant
The authority to operate this equipment is conditioned by the requirement that no
modifications will be made to the equipment unless the changes or modifications are expressly
approved by the manufacturer.
Warning
The WEEE symbol on the product indicates that the product must not be disposed of with normal household
waste. Instead, such marked waste equipment must be disposed of by arranging to return to a designated
collection point for the recycling of waste electrical and electronic equipment. Separating and recycling this
waste equipment at the time of disposal will help to conserve natural resources and ensure that the
equipment is recycled in a manner that protects human health and the environment
WEEE Compliance
MNL-1012 Rev A
vi
ISO Certification
Ocean Insight, the applied spectral knowledge company, has been certified for ISO 9001:2015 certification applicable
to the design and manufacture of electro-optical equipment.
This device has been tested and complies with the following standards:
Electromagnetic Compatibility Directive –2004/108/EC
EN 61326-1:2013
EN 55011:2009 w/A1:2010
MNL-1012 Rev A
1
Introduction
Product Description
Flame spectrometers are built using industry leading manufacturing techniques that help deliver high thermal stability and low unit to
unit variation without compromising the flexibility and configurability that are the hallmark of the design. Features such as
interchangeable slits, indicator LEDs and simple device connectors deliver more freedom and less frustration.
Features
•Plug-and-play capability via the micro-USB connection.
•User-interchangeable slit.
•LEDs show power and data transfer status.
•Compact and lightweight.
•Choice of USB or RS-232 serial communications.
•8 GPIO pins and the ability to provide power to external devices through the 40-pin connector.
Items Included With Shipment
•Flame Spectrometer
•Micro USB Cable
•Wavelength Calibration Data Sheet (please save the Wavelength Calibration Data Sheet for future reference)
MNL-1012 Rev A
2
Installation and Setup
Software Installation
Use OceanView version 1.5 and above for Flame. You can use OceanView on the following operating systems:
Windows
Apple
Linux
8
8.1
10
OS X Version 10.5 or later on
Intel processor
Any version released for an x86
or amd64 platform since 2010
*Software may run with previous operating systems but Ocean Insight does not actively support these installations.
Consult the OceanView manual for hardware requirements when using OceanView.
NOTE
Be sure to install the spectroscopy application BEFORE connecting the spectrometer to your PC. The software installs the
drivers required for spectrometer installation. If you do not install the software first, the system will not properly recognize the
spectrometer. If you have already installed the Flame to a computer running on a Windows platform prior to installing the
operating software, consult the Troubleshooting section for information on correcting a corrupt Flame installation.
NOTE
Be sure that you download the correct software package for your computer version (32 or 64-bit). See the Frequently Asked
Questions in Troubleshooting for more information on determining your computer version.
Tabla de contenidos
Otros manuales de Equipo de laboratorio de Ocean Insight
Manuales populares de Equipo de laboratorio de otras marcas
Agilent Technologies
Agilent Technologies 5800 ICP-OES Manual de usuario
Endress+Hauser
Endress+Hauser Cleanfit CPA875 Manual de usuario
NI
NI PXI-5422 Manual
Collomix
Collomix Aqix Manual de usuario
SPEX SamplePrep
SPEX SamplePrep 6875 Freezer/Mill Series Manual de usuario
Parker
Parker ALIGN-MG-NA Manual de usuario
