2
What’s in the box
1. GyroSet Glory headset
2. Micro USB to USB charging/data cable
3. USB dongle
Operation
Note: Please do not turn the headset on while in the box. Turning the headset on while
the mode selector button is pressed resets the device.
The device does work as a mouse even if it the driver software wasn’t successfully installed.
1. Take a charged headset.
2. Plug in the dongle (there may be various USB ports, if it doesn’t work in one try
another)
3. Wait 5-10 seconds, until your operating system recognises that there is some-
thing plugged in the USB port
4. Turn on the headset (slide the small switch to the left) and leave it steady for 10
seconds so the sensors can initialise.
5. Position your head to face the screen, look at the centre of the screen.
6. Push the mode selector button (big button) at the back, you should see the cur-
sor moving
7. Position the blink sensor
a. near your eye (about 1 cm distance from the corner of your eye) so that it can
see you blinking but it does not disturb you.
b. near your cheek (about 0.5-1 cm distance from your skin) - you may have to
experiment with it as it is a little bit dierent for everyone.
8. You are done!
9. ------------------------------
10. You can switch between headset mode and normal mouse by pushing the mode
selector button (big button).
11. If you push the mode selector button, the cursor will always appear at the cen-
tre of the screen. This allows you to set and reset the cursor if needed.
