- 5 -
Ⅱ. Detailed Operating Instructions:
HOWTOUSE:
1. Installation of the unit: Lift the heating unit out of the wooden packing base after you open the
package; place it flat in a spacious position; check whether the unit is damaged during transportation;
after you confirm that it has no mistake, please push it flat to the installation position and ensure that it
is stable.
(1) Please be sure to check whether the clamp or flange bolts of the external hose are tightened. After
the liquid is added, please observe whether there is water leakage at the pipe joint. If there is water leakage,
please deal with the problem in time.
(2) After it is well placed, please wipe the inner and outer surfaces of the container gently with a wet
cloth to remove the protective oil and keep the container clean.
2. When you use the unit, please fix it on a fixed platform and open the valve of the water inlet. Then,
inject clean water into the box (in order to shorten the heating time, warm water can also be added).
After water is added, please close the water inlet valve.
3. Connect the power supply and turn on the switch; set constant temperature according to detailed
operations of the thermostat (refer to the following instructions).
4. After the unit is heated and had constant temperature set, please dip the hot pack into water and
hang it on columns at both ends of the separation frame.
5. When taking out the moist heat pack from the unit, please use the clamps configured by the
unit. Do not do operations with bare hands so as to avoid being scalded.
Detailed operating instructions on the temperature controller: (1) Panel
Instruction:
