NovaLynx Corporation
110-WS-25SP-20 Page 6 August 2022
CAUTION – Connect battery power to the logger BEFORE connecting the solar panel to the system.
Otherwise the logger may not "boot" properly, or excessive voltage may be applied to
the logger system. Do the reverse when powering down, i.e. disconnect the solar panel,
and then unplug the battery to turn off the logger.
CAUTION – The solar panel produces electricity whenever it is exposed to sunlight. There is always
the danger of short-circuiting which could cause sparks or damage to other electrical
equipment if not connected properly. It is advisable to cover the solar panel with an
opaque cloth while connecting the cable.
It is best to "boot" the logger from the battery before connecting the solar panel to the system. In the
case of NovaLynx loggers, this means connect the red battery connector to the positive battery
terminal first. The logger will start up normally and the battery will be in the circuit when the charger
connection is made. Cover the panel with an opaque cloth. Connect the solar panel by plugging the
quick-connect plug on the solar panel cable into the quick-connect plug inside the logger enclosure.
After the solar panel is connected, remove the opaque cloth from the panel. Note: in some systems the
battery is in a separate enclosure from the logger. In this case route the cable from the solar panel to
the battery box.
6 OPERATION
The operation of the regulator is completely automatic. The controller will regulate the charging of the
battery during conditions of heavy usage, and when left unattended for long periods of time.
Intelligent Charge & Maintain
The built-in intelligent MPPT charge controller chips generate at least 10%-20% more power than
traditional controllers. The smart 3-stage charging algorithm is improved to better charge and
maintain a 12v battery, keeping the battery topped off in all seasons.
Protection
Protects the battery from over-charge, over-voltage, discharge, short circuit, and reversed polarity.
The electronics are waterproof and spark-proof.
Adjustable Pole Mount Bracket
The pole mount bracket allows you to easily adjust the solar
panel angle from 0-15-30-45-60 degrees. The mounting
bracket is designed for a pole diameter of 1.5 to 3.0 inches
(40-80mm). A removable V-block insert has been added to
accommodate even smaller poles.
