L、Keyboard tray fold up adjustment
ww w.nb av mou nt.co m TEL: 86-512-57971777
FAX: 86-512-57970776
Clockwise t o reduce
tension(c arry less weight)
Anti-cloc kwise to increase
tension(c arry more weight)
Warning！
Add:58, South of Xinxing Road,
Economic Development Zone.
Kunshan City, Jiangsu Province, China.
215333.
Do not adjust tension without putting on display.
1.Ensure display has been put onto mount.
2.Read your display packaging or manual to find
out display net weight.
3.Ensure display net weight between 6.6~19.8lbs
(3~9kg).
TENSION ADJUSTMENT
AFTER INSTALLED
95°
b
1 2
Note：
The pre-sre force is
at the medium.
Warning:
Ensure screws are
secured firmly.
D、Display installation
VESA:75x75mm,100x100mm
75x75mm
100x100mm
6
5
G、Display height adjustment
E、Rotation Restriction
F、Torque adjustment
Non-proper usage directions Proper usage directions
J、Keyboard tray extends adjustment
360°
-15°
+12°
H、Tilt angle adjustment
I、Display rotation
D
( )5mm
K、Keyboard tray angle adjustment
Inclined adjustment Declind adjustment
Declind adjustment:
Inclined adjustment:
①Turn screw anti-clockwise direction using 3mm Allen key D to
release. ②Turn screw clockwise direction using 3mm Allen key
D to tilt upright angle.③Turn screw clockwise direction using
3mm Allen to tighten and secure set angle.
①Turn screw anti-clockwise direction using 3mm Allen key D to
tilt down side angle.②Turn screw clockwise direction using
3mm Allen to tighten and secure set angle.
1
-12°
+12°
①
③②
D
（3mm）
-12°
+12°
D
（3mm）
①
②
0~60mm
2 3
6
a
b
"+ "：Torque increase direction shown fig-1
"- " Torque decrease direction shown fig-2：
fig-1
fig-2
D
( )5mm
Notes：Ensure display weight is within load range.
If display and keyboard tray can be hovered at any height after
display installed. No adjustment needed.
1.
If display and keyboard tray rise up automatically after display
installed, adjust the following: One man hand press down the
screen,the other wind set screw at the bottom of upper arm
at joint to ' – ' direction to reduce torque by using F, 5mm.
Allen key as shown in Fig-1 and Fig-2 until display and keyboard
tray can be hovered at any point of positions.
2.
I f d i s p l a y a n d k e y b o a r d t r a y a t t h e l o w e s t p o s i t i o n a f t e r
installation, repeat #2 procedures but winding set screws to ' + '
direction to increase torque as Fig-1 and Fig-2 until display and
keyboard tray can be hovered at any point of positions.
3.
A/B
Need 2 men. man A and man B.
Once set, man A push kno b down to
lock.
Man A, one han d holds arm down.
Another hand fingers push and hold
knob up to release.
Man B use both hands hold display 2
sides and adjust to desire height.
0~100mm
1.1.
2.
3.
4.
5.
