
EN -6-
• Do not place glass bottles or beverage cans in the freezer department.
Bottles or cans may explode.
• Do not place explosive or ammable material in your fridge for your
safety. Place drinks with higher alcohol amount vertically and by closing
their necks tightly in the fridge department.
• When taking ice made in the freezer department, do not touch it, ice may
cause ice burns and/or cuts.
• Do not touch frozen goods with wet hands! Do not eat ice-cream and ice cubes
immediately after you have taken them out of the freezer department!
• Do not re-freeze frozen goods after they have melted. This may cause health issues
like food poisoning.
• Do not cover the body or top of fridge with lace. This aects the performance of your fridge.
• Fix the accessories in the fridge during transportation to prevent damage to accessories.
• Do not use plug adapter.
Inalling and operating your fridge
Before arting to use your fridge, you should pay attention to the following points:
• Operating voltage for your fridge is 220-240 V at 50Hz.
• We do not take the responsibility of the damages that occur due to ungrounded usage.
• Place your fridge in a place that it would not be exposed to direct sunlight.
• Your appliance should be at lea 50 cm away from oves, Gas ovens and heater cores,
and should be at lea 5 cm away from electrical ovens.
• Your fridge should never be used outdoors or left under the rain.
• When your fridge is placed next to a deep freezer, there should be at lea
2 cm between them to prevent humidity on the outer surface.
• Do not place anything on your fridge, and inall your fridge in a suitable
place so that at lea 15 cm is available on the upper side.
• The adjuable front legs should be adjued to make sure your appliance
is level and able. You can adju the legs by turning them clockwise (or in the opposite
direction). This should be done before placing food in the fridge.
• Before using your fridge, wipe all parts back with warm water
added with a tea spoonful of sodium bicarbonate, and then rinse
with clean water and dry. Place all parts after cleaning.
• Inall the plaic diance guide (the part with black vanes at
the rear) by turning it 90° as shown in the gure to prevent the
condenser from touching the wall.
• Refrigerator should be placed again a wall with a free diance
not exceeding 75 mm.