OPERATION
FRONT BUTTON TOUCH SEQUENCE
TOUCH LED QSINE/QWAVE STATUS
0 OFF INACTIVE
1 BLUE QWAVE ACTIVE
2 RED QSINE ACTIVE
3 GREEN BOTH QWAVE AND QSINE ACTIVE
The built-in QPOINT Resonance Synchronizer technology is always on
and has been optimized for the QBASE REFERENCE.
Two pairs of QSINE and QWAVE units are also built-in and positioned
such that one QSINE and one QWAVE are physically closer to the left
half of outlets, while the other pair is closer to the right half. Since they
can be individually turned on and o, it’s possible to tailor how they
interact with the system components plugged into the back by selecting
which component goes into which outlet.
When the unit is first powered on, the LED rings on the two capacitive-
touch buttons on the front panel will be o. The left button controls the
QSINE and QWAVE units that are closer to the left-hand side. By touching
the button once, it will light up blue, indicating that the QWAVE on that
side is on, while the QSINE remains o. When the button is touched
again, the light will turn red, indicating that the QWAVE has been turned
o and the QSINE has been turned on. A third touch will cause the
button to light up in green, indicating that both the QSINE and QWAVE
on that side are on, and a final touch will turn both o again.
The right button operates the same way, independently of the left one.
EXAMPLE: Left button has activated one
QWAVE that favors the left side of the unit.
Right button has activated one QWAVE and one
QSINE that favor the right side of the unit. Two
QWAVEs and one QSINE are active TOTAL.
