4
1. Hose connection nipples and nuts
Connect the hose from the pad to the boiler.
2. Water inlet
The lid is opened when turned to the left, and locked when turned to the right.
3. Power (Boiler)
4. D/C 12V input (DC 12V Ø5.5/2.1mm, 700mAh~800mAh consumption)
Connectable 12V battery pack, adapter or car electrical cigarette socket.
5. Remote control input (PS2 port)
The boiler be installed outside the tent and connected to the wired remote
control for simple operation in the tent.
6. Fuel supply connector
Connect fuel to the boiler.
Specification: EN417 screw type with thread valve standard
For other specifications, use a nozzle convert adapter.
7. Fuel supply device
An automatic fuel supply and shutoff device is built in, which automatically
feeds and blocks fuel according to the set temperature.
8. In operation
9. CO2 sensor
When carbon dioxide (CO2) is detected, the lamp will turn on and a beep will
sound.
10. Temperature display
Setting temperature is displayed
11. Temperature control
1st button is to raise temperature. 2nd button is to lower. 3rd is power button.
Adjustable in 1 ° C increments up to 80 ° C.
12. Power (Remote control power)
13. Temperature display
Setting temperature is displayed
[Error code in temperature controller]
E0 : It is related with igniting.
For example, if igniting is not done despite power on and fuel supplying,
this error code appears after repeated igniting trial.
If the igniting continues a few times more after fire starting, it is normal
operating. All the product is operating by that mechanism.
E1 : Connecting problem between temp controller and boiler. Please make
sure that connecting pin is plugged in properly.
CO2 : Temperature controller checks CO2 density every 3~5 minutes and shows
this code if CO2 density is high.
It is very sensitive - so if you put it in the sleeping bag when use are
inside it, CO2 code may appear.
