1
Intended Use
Intended Use
The Nonin Model 2500C Charger Stand is intended for use with the PalmSAT Models 2500 and
2500A Pulse Oximeters and the Model 2500B Rechargeable NiMH (Nickel Metal Hydride)
Battery Pack.
Warnings
Do not use this product in an MR environment.
Do not use this product in an explosive atmosphere.
This product is not defibrillation proof per IEC 60601-1.
As with all medical equipment, carefully route patient cabling to reduce the possibility of patient entanglement,
strangulation, or injury to the patient.
This product should not be used adjacent to or stacked with other equipment. If adjacent or stacked use is
necessary, the product should be observed carefully to verify normal operation.
The use of accessories, sensors, cables, and power supplies other than those listed in the Parts and
Accessories List may result in increased electromagnetic emission and/or decreased immunity of this product.
To prevent improper performance and/or patient injury, verify compatibility of the monitor, sensor(s), and
accessories before use.
No modifications to this device are allowed as it may affect device performance.
Portable RF communications equipment such as cell phones or radios (including peripherals such as antenna
cables and external antennas) should be used no closer than 30 cm (12 inches) to any part of the ME system,
including cables specified by the manufacturer. Otherwise, degradation of the performance of this equipment
could result.
Cautions
This equipment complies with International Standard 60601-1-2 for electromagnetic compatibility for medical
electrical equipment and/or systems. This standard is designed to provide reasonable protection against
harmful interference in a typical medical installation. However, because of the proliferation of radio-frequency
transmitting equipment and other sources of electrical noise in healthcare and other environments, it is
possible that high levels of such interference due to close proximity or strength of a source might disrupt the
performance of this product. Medical electrical equipment needs special precautions regarding EMC, and all
equipment must be installed and put into service according to the EMC information specified in this manual.
Do not connect this product to an AC outlet controlled by a wall switch. If the switch is accidentally turned off
before the battery pack is recharged, the pulse oximeter may not function.
Grounding reliability can only be achieved when the equipment is connected to an equivalent receptacle
marked “Hospital Only” or “Hospital Grade”.
This product contains sensitive electronic components and must be repaired by trained Nonin personnel only.
Do not immerse this product in liquid.
