WWW.NOBLE-BIKES.COM
STEP 17. Using a 2mm allen key,
remove the chain stay cable guide. STEP 18. Feed the cable through the
chain stay. This is best done with the
bike upside down. (Gravity is your
friend)
STEP 19. Using a 2mm allen key
install the boom bracket cable
guide. It is best to do this aer the
housing is fed through the chain
stay.
STEP 20. Using a 2mm allen key,
install the chain stay cable guide.
STEP 21. Install derailleur housing
and ghten the cable nut with a
4mm allen key.
FASTENER TORQUE SPECIFICATIONS.
Correct ghtening torque of threaded fasteners is very important to your safety.
Always ghten fasteners to the correct torque. In case of a conict between the
instrucons in this manual and informaon provided by a component manufacturer,
consult with a qualied mechanic or the manufacturer’s customer service repre-
sentave for claricaon.
Always use a correctly calibrated torque wrench to ghten crical fasteners on your
bike. Carefully follow the torque wrench manufacturer’s instrucons on the correct
way to set and use the torque wrench for accurate results.
8
STEP 22. With the cable installed,
adjust the derailleur according to
the manufacturer’s specicaons
and install an end cap to prevent
fraying of the cable.
COMPONENT TORQUE
Derailleur hanger screws 1-2 N.m, unless otherwise specied
Road Stem steerer clamp screws 5-6 N.m, unless otherwise specied
Stem handlebar clamp screws 5-6 N.m, unless otherwise specied
Seat post clamp screw 4-5 N.m, unless otherwise specied
Seat post saddle clamp screws 9-10 N.m, unless otherwise specied
Through axle front 10-11 N.m, unless otherwise specied
Through axle rear 10-11 N.m, unless otherwise specied
Branded components Follow manufacturers torque specicaons
