- 10 – SL50 User guide – 33-60-022-000
1.8 Lighting setting
The SL50, as well as the other displays of the TOPLINE range, have five levels of backlighting :
0 = no lighting, 1 corresponds to the minimum level of lighting and 4 to the maximum level. You
have the option to set the level of lighting, either on the SL50 only, or on every TOPLINE
display of your installation :
1.8.1 SL50 setting procedure
-Press Ent key to enter LEVEL SETTING
-Using keys and , set the lighting level from 0 to 4,
-After few seconds the SL50 exits automatically the menu. The setting is saved in memory.
1.8.2 Setting procedure for every display of your installation
Follow the above procedure, then press on the
Ent
key to apply the setting to every display.
1.8.3 Colour setting
The SL50 offers the option of a red or a green backlighting :
-Using the keys and , select the CONFIG channel,
-Press Ent key to validate until the list of sub channels Valid alarm, language and lighting
appears,
-Then successively press Ent key to select lighting,
-Using keys and , select green or red,
-Press Ent to validate,
-Exit the setting menu by maintaining pressure on Ent key or wait 10s until the SL50 exits
automatically the menu. The new setting is saved in memory and is applied to all SL50 of
your installation.
1.9 Choice of the unit
You have the option to choose the display units of the channels:
-in knots or in km/hr for the log/speedometer,
-in knots or m/s for the anemometer,
-in degree Fahrenheit or in degree Celsius for the temperature,
-in meters or in feet for the depth finder.
Unit setting procedure
-Using keys and , select the channel from which you wish to change the unit
-Press Ent key until the sub channel Unit appears,
-Using keys and , select the unit and press Ent to validate,
-Exit the setting menu by maintaining pressure on the Ent key or wait 10s until the SL50 exits
automatically the menu. The new setting is saved in memory.
