RL256 Series iPad & Wi-Fi version 1.12 06/03/23
Setting DHCP or Fixed IP address (LAN only)
The Web interface will allow you to change the control port settings.
You can select whether the unit is in DHCP mode or Fixed IP mode.
Tick the DHCP box to use this mode.
Alternatively, if a fixed IP address is required for use in a system without a DHCP server then
fill out the five boxes.
1. IP Address – type the required IP address.
2. Subnet – type the required subnet mask.
3. Gateway – type the IP address of the gateway.
4. DNS1 – type the address of
a. the required DNS1 server
b. or 0.0.0.0 if no DNS1 is required.
5. DNS2 – type the address of
a. The required DNS2 server
b. Or 0.0.0.0 if no DNS2 is required.
6. Once all five boxes have a valid value the Submit button will appear
7. Press the Submit button to set these values.
8. If the unit has had a fixed IP set and it can’t be accessed on the current network go
to the RL256 LCD and press Sys, then Control and press the Restore Defaults button
to return the unit to DHCP mode.
