DIMENSIONS
6
CONTROLLING OTHER NITEC UFI-COMPATIBLE MODELS
WITH THE KWIK-GIG
The KWIK-GIG can be congured to control any NITEC model that is UFI-compatible. The
control signal can be transmiited over DMX cable (wired) or by UFI wi- transceivers
(wireless). Setup for both methods described below.
Note: Slave units should be congured before conguring master unit
WIRED CONNECTION OF NITEC MODELS TO KWIK-GIG MASTER UNIT
Slave units:
Set all slave units to 3-channel mode
Set DMX addresses to match the KWIK-GIG head that will control the slave unit
- Slave units controlled by Head 1, set to address 1
- Slave units controlled by Head 2, set to address 7
- Slave units controlled by Head 3, set to address 13
- Slave units controlled by Head 4, set to address 19
Connect all slave units in DMX cable daisy chain
Connect rst slave unit to the KWIK-GIG DMX Out
KWIK-GIG Master unit:
Set to Auto mode or enable footswitch control
Link rst slave unit to the KWIK-GIG’s DMX Out connector
WIRELESS CONNECTION OF NITEC MODELS TO KWIK-GIG MASTER UNIT
Slave units:
Set all slave units to 3-channel mode
Set DMX addresses to match the KWIK-GIG head that will control the slave unit
- Slave units controlled by Head 1, set to address 1
- Slave units controlled by Head 2, set to address 7
- Slave units controlled by Head 3, set to address 13
- Slave units controlled by Head 4, set to address 19
Set UFI transceivers to preferred receiving channel (1-16)
Attach one UFI to the USB port of each NITEC model
KWIK-GIG Master unit:
Set to Auto mode or enable footswitch control
Set UFI to chosen transmitting channel (1-16)
Attach UFI to the KWIK-GIG's USB port
15
