5
EN
Telephone Helpline: 0845 146 2887
Tips for use:
• Avoid opening the door too often. Opening the
door for long periods can cause a significant
increase of the temperature in the appliance.
• If the gasket or door seal is damaged or
deformed, energy consumption will increase. To
restore efficiency, replace in time.
• If the appliance is left empty for long periods,
switch it off. Then defrost and clean it thoroughly.
Let it dry well and leave the door open to prevent
mould developing within the appliance.
• Clean regularly surfaces that can come in contact
with food and accessible drainage system.
• Condensation will form in refrigeration with
frequent opening of the doors and on hot humid
days, please ensure condensation is allowed to
drain properly or is wiped dry.
Cleaning, Care &
Maintenance
• Switch off and disconnect from the power supply
before cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These can
leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• If left unused for any length of time, store the
appliance with the door ajar.
Auto Defrost
Periodically the appliance will run an automatic
defrost cycle to prevent any ice build-up.
Note: In case of Ice built-up (3-5mm thick), set the
thermostat to “O” and leave the door open. Then
manually defrost the appliance. Never use sharp
objects for scraping.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault Probable Cause Solution
The appliance is not
working
The unit is not switched on Check the unit is plugged in correctly and switched on
Plug or lead is damaged Replace plug or lead
Fuse in the plug has blown Replace the fuse
Mains power supply fault Check mains power supply
Appliance is noisy or
works intermittently
Appliance is not level Adjust the feet to level the appliance
The appliance is touching a
neighbouring object
Check installation position and change if necessary
Cooler cabinet is not
cold enough
Temperature set incorrectly Check temperature and reset if necessary
External environment may
require colder temperature
Check temperature and reset if necessary
The door is opened too often Only open when necessary
Door seal is worn Replace the seal
The light does not
work
Bulb has blown Call Nisbets Essentials agent or qualified technician
Door will not close
properly
Cooler is not level Adjust the feet
Door has been reversed and
not properly fitted
See “Reverse the door”
Shelves are out of position Check all shelves are properly inserted
Door seal is dirty Wipe clean with a damp cloth
DB303_EN_A5_v2_20220317.indb 5DB303_EN_A5_v2_20220317.indb 5 2022/3/17 17:232022/3/17 17:23
