2Qanto_Id_A4_00000.50.65053_US
General assembly instructions
•Anyone who performs connection or assembly work on Qanto must
have access to these assembly instructions. Follow these instructions.
Non-observance of the above mentioned instructions can lead to acci -
dents resulting in severe personal injury, such as trapped fingers and
electric shock.
•Assembly may be performed by expert personnel only, as incorrect
assembly may lead to injury or electric shock.
clearance from the edge of the counter, otherwise there is a risk of
injury.
• If the product is visibly damaged, it must not be installed, as a possible
malfunction may lead to injury or electric shock.
for the movement of the lifting system. When Qanto is extended upward
and to both sides, a clearance of about 7,87“ (200 mm) to other cabinets
or shelving must be observed, otherwise there is a risk of injury.
•A clearance of 11,82“ (300 mm) must be observed between Qanto and a
gas stove, as heat may cause damage to the unit.
•The electrical system of Qanto must be accessible (e.g., a double so-
cket under the cabinet near the base).
• Make sure the cables are undamaged, as this may lead to electrical shock.
• Before connecting the electrical drive to the in-house power mains,
on the type plate. The mains voltage and permissible input voltage must
be identical. If not, Qanto must not be connected.
• If the control unit causes unusual noises or odours during operation,
•
interrupt the power supply.
Select the length of the fastening screws for the bars in such a way that
they do not poke through the cabinet, otherwise the unit will be damaged
and this may lead to injury.
NOTICE
EN
