Ninja Master Prep QB900NZ 30 Manual de usuario

Master Prep™

QB900NZ 30

QB900NZ_30_120626_1.indd 1 12-06-26 12:58 PM

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

For Household Use Only

WHEN USING ELECTRICAL

APPLIANCES, BASIC SAFETY

PRECAUTIONS SHOULD ALWAYS

BE FOLLOWED, INCLUDING THE

FOLLOWING:

READ ALL INSTRUCTIONS BEFORE

USING YOUR NINJA™ MASTER

PREP™.

IMPORTANT: This appliance

can be used by children aged from

8 years and above and persons

with reduced physical, sensory

or mental capabilities or lack

of experience and knowledge if

they have been given supervision

or instruction concerning use of

the appliance in a safe way and

understand the hazards involved.

Children should be supervised to

ensure that they do not play with

the appliance. Cleaning and user

maintenance shall not be made by

children without supervision.

WARNING:

TO REDUCE THE RISK OF FIRE, ELECTRIC

SHOCK OR INJURY:

1. Close supervision is necessary

when any appliance is used by or

near children.

2. To protect against electric shock,

DO NOT immerse cord, plug or

any part of the main unit in water

or any other liquids.

3. DO NOT let cord hang over edge

of table or counter, or touch hot

surfaces.

4. DO NOT operate the appliance

with a damaged plug or cord,

or if the unit has been dropped,

damaged or dropped in water. To

avoid the risk of electric shock,

do not disassemble or attempt to

repair the appliance on your own.

If the supply cord is damaged, it

must be replaced by a qualiﬁed

electrician in order to avoid a

hazard. Incorrect re-assembly or

repair can cause a risk of electrical

shock or injury to persons when

the appliance is usedt.

5. Unplug appliance from outlet

when not in use and before

cleaning.

6. DO NOT place on or near a hot

gas or electric burner.

7. The use of accessory

attachments, including canning

jars not recommended by the

manufacturer may cause ﬁre,

electrical shock or risk of personal

injury.

8. Extreme caution must be used

when moving an appliance

containing hot food, water or

other liquids.

QB900NZ_30_120626_1.indd 2 12-06-26 12:58 PM

23. DO NOT operate the appliance

empty.

24. If the appliance overheats, a

thermal switch will become

activated and shut off the motor.

To reset, unplug the appliance and

let it cool down for approximately

10 minutes before using again.

25. THIS PRODUCT IS INTENDED

FOR HOUSEHOLD USE ONLY.

Do not use this appliance for

anything other than its intended

use. Do not use outdoors.

WARNING: Extension

cords are not recommended for use

with this product.

SAVE THESE

INSTRUCTIONS

9. Use this appliance on a stable

work surface away from water.

10. DO NOT remove the motor head

before the chopping blades have

stopped turning.

11. CAUTION! Chopping blades are

sharp, handle with care. When

handling the chopping blades,

always hold by the plastic shaft.

12. DO NOT attempt to sharpen

blades.

13. DO NOT expose pitcher to

extreme temperature changes.

14. DO NOT use pitcher if it is cracked

or chipped.

15. DO NOT use the appliance if

chopping blades are bent or

damaged.

16. Avoid contact with moving parts

at all times. Keep hands, hair,

clothing as well as spatulas and

other utensils away from pitcher

during operation to prevent risk of

personal injury and/or damage to

the appliance.

17. Exercise extreme caution when

blending hot liquids.

18. Immediately release the On/Off

pulse button on the motor head

in the event that the appliance

malfunctions during use.

19. To reduce the risk of injury, NEVER

operate the appliance without the

splash guard in place; DO NOT try

to defeat the interlock mechanism;

make sure that the cutting blades

are properly assembled before

operating the appliance.

20. DO NOT use outdoors.

21. DO NOT use appliance for other

than intended use.

22. DO NOT operate the appliance for

more than 15 seconds.

QB900NZ_30_120626_1.indd 3 12-06-26 12:58 PM

TECHNICAL SPECIFICATIONS

Voltage: 220-240V~, 50Hz.

Power: 400 Watts

Pitcher Capacity: 1.5 L (48 ounces) (6 cups)

Bowl Capacity: 0.5 L (16 ounces) (2 cups) Z854

SAA110120EA

QB900NZ_30_120626_1.indd 4 12-06-26 12:58 PM

Contents

Getting Started ......................................................................6

Using the Master Prep™ Pitcher .......................................8

Using the Master Prep™ Bowl ...........................................10

Cleaning and Maintenance ................................................12

Troubleshooting Guide .......................................................12

Thank you for

purchasing

the Ninja™

Master Prep™.

QB900NZ_30_120626_1.indd 5 12-06-26 12:58 PM

j Pitcher Storage Lid

k Pouring Spout

l Pitcher Splash Guard

m Upper Blade (pitcher)

n Lower Blade (pitcher)

o Master Prep™ Pitcher

p Spindle Pin

q Non-Slip Base Gasket (pitcher)

r Power Cord (not shown)

a Bowl Splash Guard

b Upper Blade (bowl)

c Lower Blade (bowl)

d Master Prep™ Bowl

e Spindle Pin

f Non-Slip Base Gasket (bowl)

g On/Off Pulse Button

h Power Head

i Bowl Storage Lid

Getting Started

QB900NZ_30_120626_1.indd 6 12-06-26 12:58 PM

400 Watt Power Head

The 400 watt power head operates on 220-240V~, 50Hz electrical power. NEVER

allow the power head to become wet when plugged into an electrical outlet.

WARNING: The power head should never be immersed in water or any other liquid.

CAUTION: Make sure that the power head is unplugged from the electrical outlet and

that the blades have stopped turning before attaching or removing any accessory.

CAUTION: Blades are sharp! Use extreme caution when handling the blades.

Always hold them by the shaft. Do not attempt to sharpen blades.

IMPORTANT: Never run the appliance empty.

The Ninja™ Master Prep™ is an indispensable kitchen tool that is perfect for blending,

chopping, mixing or pureeing when preparing your favorite recipes. For best results,

be sure to carefully read all the instructions contained in the manual before using this

appliance.

QB900NZ_30_120626_1.indd 7 12-06-26 12:58 PM

Using the Master Prep™ Pitcher

WARNING: DO NOT try to place the

blades onto the power head and then

into the Master Prep™ pitcher.

Shaft

CAUTION: Blades are sharp! Use

extreme caution when handling the

blades. Always hold them by the shaft.

IMPORTANT: Never run the appliance

empty.

1 Place the Master Prep™ pitcher on a

clean, dry, level surface.

2 Holding the lower blade by the shaft,

place it onto the spindle pin inside the

Master Prep™ pitcher. (Fig. 1)

3 Carefully insert the upper blade over

the lower blade rotating it until it locks

onto the lower blade. (Fig. 2)

IMPORTANT: Always assemble the

blades inside the container.

QB900NZ_30_120626_1.indd 8 12-06-26 12:58 PM

Pouring Spout

4 Add the ingredients to be processed

into the Master Prep™ pitcher.

IMPORTANT: The blade assembly for

the Master Prep™ pitcher must always

be in place before ingredients are

added.

5 Place the pitcher splash guard onto the

top of the Master Prep™ pitcher. (Fig. 3)

6 Place the power head on top of the

pitcher splash guard making sure that

it is securely in place. (Fig. 4) DO

NOT attempt to operate the appliance

without the safety splash guard in

place.

7 To start the appliance, plug the power

cord into the electrical outlet, securely

hold power head while operating

and press on the on/off pulse button

located on the top of the power head.

(Fig. 5)

8 Hold the Master Prep™ pitcher ﬁrmly

while depressing the on/off pulse

button to ensure the unit stays in place.

NOTE: DO NOT operate the appliance

continuously for more than 15 seconds

at a time.

9 To stop the appliance, remove your

ﬁngers from the on/off pulse button.

10 In order to obtain a better quality of

chopping, operate the appliance by

using the “Pulse” method.

11 Make sure that the blades have

stopped completely before removing

the power head.

12 If the ingredients stick to the side of

the Master Prep™ pitcher, stop the

appliance, remove the power head

and the splash guard. Use a spatula to

dislodge the pieces and then replace

the splash guard and the power head.

Continue processing.

13 Depending on the consistency of the

contents, use the pouring spout to

empty liquid contents.

14 For thicker consistencies, ﬁrst remove

splash guard and blade assembly (by

its shaft), then empty contents of the

Master Prep™ pitcher.

QB900NZ_30_120626_1.indd 9 12-06-26 12:58 PM

Using the Master Prep™ Bowl

Shaft

CAUTION: Blades are sharp! Use

extreme caution when handling the

blades. Always hold them by the shaft.

IMPORTANT: Never run the appliance

empty.

1 Place the Master Prep™ bowl on a

clean, dry, level surface.

2 Holding the lower blade by the shaft,

place it over the spindle pin inside the

Master Prep™ bowl. (Fig. 1)

3 Carefully insert the upper blade over

the lower blade rotating it until it locks

onto the lower blade. (Fig. 2)

IMPORTANT: Always assemble the

blades inside the container.

WARNING: DO NOT try to place the

blades onto the power head and then

into the Master Prep™ bowl.

4 Place the food that you want to process

into the Master Prep™ bowl.

IMPORTANT: The blade assembly for

the Master Prep™ bowl must always be

in place before ingredients are added.

NOTE: DO NOT add more than 2 cups

dry or 1 cup liquid ingredients as this

will strain the motor and may cause

overﬂow.

QB900NZ_30_120626_1.indd 10 12-06-26 12:58 PM

Tabla de contenidos

Otros manuales de Procesador de alimentos de Ninja

Ninja

Ninja Express Chop NJ100 Series Manual de usuario

Ninja

Ninja Foodi SS200 Series Manual de usuario

Ninja

Ninja BL488ANZ Manual de usuario

Ninja

Ninja BL771 series Manual de usuario

Ninja

Ninja NJ100NZ Manual de usuario

Ninja

Ninja CT682SP Manual de usuario

Ninja

Ninja CT800 Series Manual de usuario

Ninja

Ninja Master Prep Professional QB1004NZ 30 Manual de usuario

Ninja

Ninja Precision Processor Manual de usuario

Ninja

Ninja Express Chop NJ100 30 Manual de usuario

Ninja

Ninja Express Chop NJ100 Series Manual de usuario

Ninja

Ninja NN100 Series Manual de usuario

Ninja

Ninja PROFESSIONAL FOOD PROCESSOR WITH AUTO-IQ Manual de usuario

Ninja

Ninja Master Prep QB1000UK series Manual de usuario

Ninja

Ninja NJ100 Manual de usuario

Ninja

Ninja NJUK series Manual de usuario

Ninja

Ninja BL780WM Manual de usuario

Ninja

Ninja Master Prep QB1000QUK series Manual de usuario

Ninja

Ninja PROFESSIONAL XL Manual de usuario

Ninja

Ninja NN310 Series Manual de usuario

Ninja

Ninja Kitchen System 1200 Manual de usuario

Ninja

Ninja Express Chop NJ100C Manual de usuario

Ninja

Ninja Master Prep Professional QB1005Q Manual de usuario

Ninja

Ninja NJ10XXNZ Manual de usuario

Manuales populares de Procesador de alimentos de otras marcas

INNOLIVING

INNOLIVING INN-727 Manual de usuario

Berkel

Berkel C32 Manual de usuario

Beko

Beko CHP5554W Manual de usuario

KitchenAid

KitchenAid 5KFP0719 Manual de usuario

QUIGG

QUIGG KM 2017Wi.20 Manual de usuario

Lakeland

Lakeland PRESS AND CHOP 31557 Manual de usuario

Bosch

Bosch MMR08 GB Series Manual de usuario

HOFFEN

HOFFEN Chef Express T9532 Manual de usuario

Garland

Garland 852 ZG Manual de usuario

Robot Coupe

Robot Coupe CL50 Gourmet Manual de usuario

SAPIRHOME

SAPIRHOME SP-1111-K Manual de usuario

Moulinex

Moulinex DJ3051 Manual de usuario

Bosch

Bosch MUM5 Manual de usuario

cecotec

cecotec Mambo Touch Manual de usuario

KitchenAid

KitchenAid 9KFC0516 Manual de usuario

Black & Decker

Black & Decker hc 300 Instrucciones de instalación

Gorenje

Gorenje SBR 1000 DV Manual de usuario

Arzum

Arzum AR 1128 Manual de usuario