Ningbo VSETT EAGLE Manual de usuario
NINGBO VSETT INTELLIGENT TECHNOLOGY CO., LTD
USER MANUAL
USER MANUAL
PLEASE READ THE INSTRUCTIONS CAREFULLY BEFORE RIDING
STRONG TORQUE
OFF - ROAD
TFT DISPLAY
HYDRAULIC BRAKE
CONTENT
Safety Checklist
Safety Precautions
SAFETY
1-2
3
Bike Specifcation
Bike Assembly Guide
Assembly Instructions
Battery
LCD Display Settings
Walk Mode and Pedal-Assist
Set Interface
Riding Modes
Riding Limitations
Parking & Transport
Carrying Loads & Cargo
Safety and Care Instructions
USING AND CARE YOUR E-BIKE
4-7
8
8-12
13
14
15
16
17
18
18
19
20
Battery Maintenance
Chain Maintenance
Front Fork Maintenance
Brake Maintenance
MAINTENANCE
21
21
21
22
LIMITED WARRANTY
ERROR CODES
INCLUDED IN THE BOX
23-25
25
25
Brakes
Wheels and Tires
Chain
Cranks and Pedals
Derailleurs
Motor Drive
Safety Check
• Check that chain is oiled, clean and runs smoothly.
• Use extra care in wet or dusty conditions.
• Securely tighten pedals to cranks.
• Ensure cranks are securely tightened and are not bent.
• Check that derailleur(s) are adjusted and functioning properly.
• Ensure shift and brake levers are attached to handlebar securely.
• Check all brake and shift cables for proper lubrication.
• Ensure hub motor is spinning smoothly and motor bearings are in good working order.
• Check that all power cables running to hub motor are secured and undamaged.
• Make sure hub motor axle bolts are secured and all torque arms and torque washers are in place.
Basic Steps
• Test front and rear brakes for proper function.
• Ensure brake pads are not overworn and are correctly positioned in relation to rims.
• Make sure brake control cables are lubricated, correctly adjusted and display no obvious wear.
• Check that brake control levers are lubricated and tightly secured to handlebars.
• Inflate tires to within recommended limits displayed on sidewalls.
• Check for bulges or signs of excessive wear.
• Clean tires to ensure tread is exposed.
• Ensure rims run true and have no obvious wobbles or kinks.
• Check that all wheel spokes are tight and not broken.
• Check the wheel balance in Pedal Only Mode. If you notice the riding is imbalanced or the rotation of the front wheel makes noise,
it means the bolts were not completely tightened or not aligned horizontally.
1
SAFETY CHECKLIST
Battery and charger
• Ensure battery is charged before use.
• Check for any visible damage to battery pack.
• Lock battery securely to frame.
• Keep the battery away from children and pets.
• Keep the battery & charger away from water and open fire.
• Do not drop or subject the battery & charger to any big shocks.
• Charge the battery only with the charger that was supplied with the e-bike, or the spare / replacement charger supplied by an
official dealer.
• Do not use the battery & charger for other purposes.
• Never connect the battery's terminals with each other.
• Do not cover the battery & charger or place objects on top of it during charging.
• Do not leave the battery & charger unattended while charging.
• Disconnect the charger and the battery immediately if you notice a strange smell or smoke.
• In the unlikely case that the battery is on fire: NEVER try to put the fire out with water. Cover the fire with large amounts of sand,
and call emergency services immediately.
NOTICE: When the battery has reached the end of the service life, it should be treated as hazardous waste material. It should not be disposed of in regular household
trash. Ask your dealer for advice on proper disposal of the battery.
2
BEFORE RIDING
All users must read and understand this manual before first use. Additional manuals for components used on your bicycle may be provided and should also be read
before use.
Ensure you understand all instructions and safety notes/warnings.
Ensure the bike fits you properly before first use. Check local rules and regulations before riding.
It is your responsibility to familiarize yourself with the laws and requirements of operation of this product in the area(s) where you ride.
Always wear an approved bicycle helmet whenever using this product and ensure that all helmet manufacturer instructions are us ed for fit and care of your helmet.
Failure to wear a helmet when riding may result in serious injury or death.
Acceleration can be unexpectedly strong in pedal assist mode (Pedal Assist level 1-5), as when you pedal the motor assist will suddenly engage. Therefore, please
pay careful attention when riding. We suggest you use Pedal Only Mode (Pedal Assist level 0) when you need to ride at a slow speed to cross roads, at intersections,
or when pedestrian traffic is present, in order to avoid accidents caused by sudden acceleration.
Make sure you securely close the quick-release lever of the front wheel, checking the wheel balance in Pedal Only Mode. If you notice the riding feels imbalanced, or
the rotation of the front wheel makes noise, it likely means the bolts were not completely tightened or didn’t align horizontally in the center.
Off-road riding requires close attention and specific skills, and presents variable conditions and hazards which accompany the conditions.
Wear appropriate safety gear and do not ride alone in remote areas.
WHILE RIDING
SAFETY PRECAUTIONS
The following safety notes provide additional information on the safe operation of your VSETT EAGLE and should be closely reviewed. Improper operation, or failure to confirm
correct installation, compatibility, and maintenance of any component or accessory may result in serious injury or death.
3
BIKE SPECIFICATION
4
ADJUSTABLE PNEUMATIC SHOCK
LED LIGHTS
S-RIDE 7-SPEED SHIFT SYSTEM
HIGHLIGHT BRAKE LIGHT
LIQUID SHOCK ABSORBER
180MM DISC BRAKE
HYDRAULIC BRAKE
750W MOTOR (TOP SPEED 4KM/H)
48V 22A CONTROLLER
48V 20AH BATTERY (80KM RANGE)
KENAD 20×40 INFLATABLE TIRE
HYDRAULIC BRAKE
SHOCK ABSORBER
ADJUSTABLE KNOB
ADJUSTABLE KNOB
5
GEAR SHIFT BUTTON +
MENU
THROTTLE
ON/OFF
GEAR SHIFT BUTTON -
SHIFT LEVER
SHIFT LEVER
6
VSETT-Eagle E Bike
Samsung 21700 (5000mah)
Rear Wheel 48V 750W Brushless Motors
960Wh
48V 20Ah
48V 22A
41.6KG (including the battery weight)
11HR+ (USE a standard 2A Charger)
40 KM/H
About 80KM
150KG
1840mm×710mm×1080mm (length×width×height)
12V 10W high power LED front lamp, 6V high brightness LED brake tail lamp
Pneumatic front fork with locking and multi-shift adjustment function
Model
Battery
Motor
Total Discharge
Specification
Controller
Weight
Charging
Speed
Max Range
Max loading
Open Size
Light
Front Fork
7
Suspension
Chain
Transmission
Free Wheel
Drive mode
Spoke
Crank
Brake
Tyre
Material
Function
Adjustable oil suspension
(spring 800 Pounds、Compression damping 90N、Minimum recovery damping 150N Maximum recovery damping 5300N)
KMC Chain
S-Ride 7-speed shift system
S-Ride 14-28T
Boost mode, throttle mode
12G
155mm aluminum alloy forging
Both oil pressure disc brake / Front and rear brakes automatically power off function
Brake Disc 180MM
20*4.0 inch Pneumatic tire / Recommended tire pressure: 30-35psi
Frame: 6082-T6 special high strength aluminum alloy for aviation forging
7-speed transmission, with magnetic suction storage box, wireless charging in the storage box,
pneumatic front fork band locking multi-shift adjustment, shock absorption handle,
headlight illumination angle adjustable
BIKE ASSEMBLY GUIDE
ASSEMBLY INSTRUCTIONS
8
• Preparation Checklist
1. Loosen four screws of T Bar Block cover
and remove the T Bar Block cover.
Front TireBicycle Frame Pedals
Tabla de contenidos
Otros manuales de Scooter de Ningbo
