Page 4of 5
the outer oor frame an the corner post of the fixe panel to a istance of 300mm, refer D
Silicone on the outer e ge only. Fix the frame to the corner posts by rilling into the corner post using
the pre rille holes in outer frame as a gui e. Use a 3mm rill bit an fit four 6 x 12mm square rive
screws to each si e of the frame. Locate the two rolle lengths of plastic screw capping an cut to length
to fit into the slot to cover the screw hea s (refer Diagram 3 above). When fitting, press gently into
position at several points along the length of the capping, to avoi stretching the material an work from
the top own. The two si e panels an outer oor frame are now resting on the tray but are not secure
to the wall profiles.
STEP 4 4mm framed door o ly Cut an arrowhea on the vinyl seal an insert it in the slot un er the
bottom e ge of the oor. Insert from the pivot block en with the curve face of the vinyl seal facing the
outsi e of the unit. Trim to full wi th of the oor with a sharp knife. Avoi excessive stretching of the
material as it will shrink back to length an may finish up being too short (Diagram 4). Insertion of the
seal is greatly assiste by spraying silicone into the slot un er the oor. Do not spray silicone onto the
vinyl as it will become ifficult to maintain a grip.
(6mm frameless door o ly) Fit the han les to the oor pane now. Cut the oor seal to butt joint against
the pivot block on both si es of the bottom pivot on the bottom e ge of the oor glass.
STEP 5 WARNING: Do not let the oor swing open without
being hel , as the fixe panels are not yet secure to the wall
profiles an the weight of the oor may cause the unit to fall
forwar .
To fit the oor first place a 3mm rill, four of the #6 x 12mm
square rive screws on the floor of the tray. Ensure that the
screw river is easily accessible an that you have the top pivot
block an its screws.
Stan ing outsi e the unit hol the oor in the open position
an locate the bottom pin into the bottom pivot block.
Maintain a firm grip on the oor panel at all times. Tilt the top
of the panel towar s the magnet si e of the oor to allow
sufficient clearance for the top pivot pin to swing inwar s
un er the top of the oor frame, place the top pivot block
onto the top pivot pin. Step into the
shower an close the oor into place on the magnet (Diag
5). Maintain a grip on the oor panel an
the top of the frame. Relocate the top pivot block in position, making sure the oor closes on the magnet
an tighten the screws.
WARNING: Do not let the oor swing open without being hel , as the fixe panels are not yet secure
to the wall profiles an the weight of the oor may cause the unit to fall forwar .
