PowerSwap Nucleus® MINI Owner's Manual | 3
Storage and Disposal
Operating Guidelines
Storage and Disposal
Storage Instructions:
• DO NOT SHORT TERMINALS.
• This battery should be stored in a cool, dry, and well-ventilated area. Sustained elevated temperatures are
the primary reason for premature failure of batteries. Charge batteries at room temperature. In warm cli-
mates, keep chargers in air conditioned rooms for best performance.
• Although our batteries have good self-discharge characteristics, batteries should be stored for long term
storage in a fully charged condition.
• It is always a good idea to submit the battery to a discharge/charge cycle from time to time during storage.
• Do not store batteries in temperatures above 140oF/60oC or below -40oF/-20oC. Do not store in direct sun-
light or near heating equipment.
Disposal Instructions:
• DO NOT INCINERATE. DO NOT DISASSEMBLE.
• Disposal must be in compliance with applicable regulations which vary depending on national, state/provin-
cial and local basis. This battery contains recyclable materials so recycling is strongly recommended.
PowerDock MINI Operating Instructions
Step 2: Place fully charged batteries
in PowerDock MINI Station. Make sure
battery is fully engaged and the LED
lights on the battery are lit. *Batter-
ies should be inserted firmly, but never
slammed into place.
Step 3: Turn PowerDock MINI
Station on (-) (switch located as
shown). LED should light green.
When unit is not in use, turn the PowerDock MINI OFF. Batteries will continue to drain if unit is left on.
Tip: Monitor battery status with the LED meter on battery. When batteries become low, alarm will sound and bat-
tery should be swapped with a fully charged one.
Step 1: Confirm your device(s) is
plugged into the AC outlet(s).
(120V model shown)
