PC Series 1 & 2 Battery Systems
with 1000W Inverter/Charger
QUESTIONS? CALL 781-935-3450 2-2-2018 Pg. 4
3. Positive Connection: Place lock washer onto bolt
first, then flat washer, then large red wire (A) in order
shown above.
7. Securely tighten terminal bolts with a
10mm wrench.
Wire A (red) comes pre-
connected from remote
battery meter to fuse block.
Wire B (black) connects
remote battery meter to
black negative (-) battery
terminal.
(C has been omitted)
Wire E (red) connects to red
positive (+) battery terminal.
(D & F have been omitted)
Wire G (black) connects to
black negative (-) battery
terminal.
5. Pull rubber boot over tightened
terminal.
4. Securely tighten terminal bolt with
10mm wrench.
3. Positive Connection: Take bolt and place flat
washer, small green wire, small red wire and large red
wire onto bolt (as show above); insert bolt through
positive (+) battery terminal; place flat washer, lock
washer, then nut onto bolt and hand-tighten
6. Negative Connection: Place lock
washer onto bolt first, then flat washer, then
small black wire (C), then large black wire
(B) in order shown above.
