3
PLEASE NOTE: It is necessary to configure the host (Sun) computer such that the Sleep Mode is not enabled. If the host computer
goes into sleep mode either automatically or manually, the user must reboot the host computer in order to resume use of the host
computer.
To disable the Sleep Mode, perform the following steps:
1. Select "Power Manager"
2. Look for "Device Idle Time Before Power Saving Starts"
3. Select "Always ON"
4. Look for "Override Device Idle Time For:"
5. Make sure neither "Monitors " nor "Disks" are selected.
Technical Specifications
PIN # SIGNAL PIN # SIGNAL
1+VCC 1GND
2- DATA 2GND
3+DATA 3+5
4GND 4MOUSE
5KYBD RCV
6KYBD XMT
7PWRN
8+5
WARRANTY INFORMATION
The warranty period on this product (parts and labor) is one (1) year from the date of manufacture (indicated on the bottom of the
product). Please contact Network Technologies Inc at (800) 742-8324 (800-RGB-TECH) or (330) 562-7070 or visit our website at
http://www.nti1.com for information regarding repairs and/or returns. A return authorization number is required for all repairs/returns.
COPYRIGHT
Copyright © 2001 by Network Technologies Inc. All rights reserved. No part of this publication may be reproduced, stored in a
retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without
the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202
CHANGES
The material in this guide is for information only and is subject to change without notice. Network Technologies Inc reserves the right
to make changes in the product design without reservation and without notification to its users.
SERIAL NO.:
INSPECTED BY:
DATE:
Fig. 6 Fig. 7
2 1
43
Mating face of a USB Type B Female
2 1
5 3
8 6
7
4
Mating Face of a 8 pin miniDIN Female
