
NETmc Marine DVR Manual-Rev7.2 Dec 2020 10 of 52
© NETmc Marine Ltd 2020
Green if more than 25% of the disk is free.
Orange if between 10% and 25% of the disk is free
Red if less than 10% of the disk is free.
To start the recording, simply click on the REC button.
When recording has started, the status indicator changes to “REC” instead of “IDLE”, the REC
button will become depressed and the minute counter will start to increment.
The image on the screen shows the video signal that is being input to the DVR.
Once the desired footage has been recorded, simply click on the STOP button to end recording.
At any point during the recording or preview, the image on the screen can be saved as a jpg file by
clicking the STILL button.
To resume logging, simply click the REC button again.
The system will automatically create a new file, automatically named as per the configuration in the
SETUP page.
If audio has been lost or disconnected from the system a warning will appear on screen.
After correcting the problem click on the red warning to re-enable audio and continue. If no audio is
required, no action needed.