8. Two modes of luminance_____ _____ ___
•In mode I hen adjusting color, brightness varies linearly,
hereas in the mode II - logarithmically (so its constant value
is maintained).
•To maintain a constant brightness in mode II, set the dimmer
dial around 75%. The red LED indicates being outside the scope of
constant luminance.
•Mode II activity is indicated by a green LED.
•Mode selection does not change the color dial function.
•The change of the characteristics applies only to the luminance
parameter.
9. Contraindications_ _
•Do not connect a higher voltage than specified.
•Do not block ventilation holes.
•There is no incentive to connect remote controllers NRC-03
ith po er on.
•Do not ash the housing ith alcohol or other solvents.
In the case of ater damage, disconnect the po er, and do not turn
on until dry.
10. External brightness/color controller_ _
•To connect the external controllers remove the rubber plugs from
the sockets.
•When connecting the controller, light should be turned off ( ith
a s itch) or disconnected from the po er source - other ise there
is a possibility of damaging the lamp.
•After connecting the external controller, the corresponding internal
dial becomes inactive ( hen the NRC-03 is connected, the
adjustment can be done only by using the controller).
•The LED in the NRC-03 controller hen connected to the brightness
control input lights green. When connected to
the color temperature input lights red.
•You can connect t o NRC-03 controllers or use just one.
11. Battery charge status ___
NOTE
•Battery charge status orks only ith 7,2V-7,4V rated voltage
Li-Ion batteries.
•Connecting higher voltage ill damage the charge status.
•The status indicates hile pressing the button on the back of
the battery adapter.
SIGNAL MEANING
All the red LEDs are blinking The battery is charged to
dangerously high voltage
(unsafe to the battery)
All the red LEDs lit continuously 100% battery charge
Three red LEDs lit continuously 80% battery charge
T o red LEDs lit continuously 60% battery charge
One red LED lit continuously 40% battery charge
None of the red LEDs lit About 20% battery charge
(time to change the battery)
