NE-1
Some Dos And Don't On The Safe Use Of Equipment
This equipment has been designed and manufactured to meet international safety standards but, like any electrical equip-
ment, care must be taken if you are to obtain the best results and safety is to be assured.
***********************************
DO read the operating instructions before you attempt to use the equipment.
DO ensure that all electrical connections (including the mains plug, extension leads and interconnections between the
pieces of equipment) are properly made and in accordance with the manufacturer’s instructions. Switch o and withdraw
the mains plug before making or changing connections.
DO consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment.
DO be careful with glass panels or doors on equipment.
DO route the mains lead so that it is not likely to be walked on, crushed, chafed, or subjected to excessive wear and tear or
heat.
***********************************
DON’T remove any xed cover as this may expose dangerous voltages.
DON’T obstruct the ventilation openings of the equipment with items such as newspaper, tablecloths, curtains, etc. Over-
heating will cause damage and shorten the life of the equipment.
DON’T allow electrical equipment to be exposed to dripping or splashing, or objects lled with liquids, such as vases, to be
placed on the equipment.
DON’T place hot object or naked ame sources such as lighted candles or nightlights on, or close to equipment. High tem-
peratures can melt plastic and lead to res.
DON’T use makeshift stands and NEVER x legs with wood screws. To ensure complete safety always t the manufacturer’s
approved stand or legs with the xings provided according to the instructions.
DON’T use equipment such as personal stereos or radios so that you are distracted from the requirements of trac safety.
It is illegal to watch television whilst driving.
DON’T adjust the volume of the headphones to be too high and use that for an extended period, it can damage hearing.
DON’T leave equipment switched on when it is unattended unless it is specically stated that it is designed for unattended
operation or has a stand-by mode. Switch o using the switch on the equipment and make sure that your family know how
to do this. Special arrangements may need to be made for inrm or handicapped people.
DON’T continue to operate the equipment if you are in any doubt about it working normally, or if it is damaged in any way-
switch o, withdraw the mains plug and consult your dealer.
ABOVE ALL,
-NEVER let anyone especially children push anything into holes, slots or any other opening in the case - this could result
in a fatal electrical shock;
-NEVER guess or take chances with electrical equipment of any kind. It is better to be safe than sorry!
***********************************
FCC
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
