Neomouv PLIMOA Manual de usuario

PLIMOA

USER MANUAL

THIS MANUAL CONTAINS IMPORTANT INSTRUCTIONS FOR

SAFETY AND OPERATION.

"Model complies with the safety requirements"

Photos and data are not binding

11-2019

 
 Manuel PLIMOA 
 
 

SUMMARY 
 
1- INTRODUCTION ........................................................................................................................................... 3 
2- ADJUSTMENTS / ASSEMBLY ........................................................................................................................ 4 
1 Adjusting the saddle: ..................................................................................................................................4 
1.1 Angle:....................................................................................................................................................4 
1.2 Height: ..................................................................................................................................................4 
2 Handlebar adjustment: ...............................................................................................................................5 
3 Brake adjustment: ......................................................................................................................................6 
3.1 V-type front brake: .................................................................................................................................6 
3.2 Rear V-type brake: .................................................................................................................................7 
4 Luggage rack: ...........................................................................................................................................7 
5 Mounting and dismounting wheels (rear wheels by specialist): ......................................................................8 
5.1 Front wheel:...........................................................................................................................................8 
5.2 Rear wheel: ...........................................................................................................................................8 
6 Lights: .......................................................................................................................................................9 
7 Folding the Ebike:.....................................................................................................................................10 
- USING THE E-BIKE.................................................................................................................................... 13 
1 Indexed gearshift: ....................................................................................................................................13 
2 The electronic shift: ..................................................................................................................................13 
3 The display and control:............................................................................................................................14 
4 The electric assistance:.............................................................................................................................15 
4.1 operation: ............................................................................................................................................15 
4.2 performance: .......................................................................................................................................16 
4.3 Technical specifications of the assistance system:...................................................................................16 
4.4 Switching on of the battery: ..................................................................................................................17 
5 The electric motor: ...................................................................................................................................17 
- CHARGING THE BATTERY ......................................................................................................................... 18 
1 NEOMOUV Lithium Ion 36-volt charger ......................................................................................................18 
1.1 Precautions (safety instructions):...........................................................................................................19 
1.2 Protecting the charger: .........................................................................................................................19 
2 Battery: ...................................................................................................................................................20 
2.1 Battery performance for electric bikes:...................................................................................................21 
2.2 Recommandations / precautions to take with your battery: .....................................................................22 
- TIPS FOR INCREASING THE BATTERY LIFE PER CHARGE ........................................................................ 23 
CARE AND MAINTENANCE........................................................................................................................... 24 
1 Care:..............................................................................................................................................................24 
2 Lubrication: ....................................................................................................................................................24 
3 Maintenance:................................................................................................................................................24 
- SAFETY - RECOMMENDATIONS................................................................................................................. 25 
- TECHNICAL DATA...................................................................................................................................... 26 
- STATEMENT OF CONFORMITY .................................................................................................................. 27 
- CERTIFICATE OF CONFORMITY .............................................................................................................. 27 
- WARRANTY CONDITIONS....................................................................................................................... 27 

Manuel PLIMOA

1- INTRODUCTION

Thank you for choosing a NEOMOUV Electric Bike

E-Bike Overview

Notes:

•The symbol indicates important advice or essential safety measures. Follow the various instructions.

•Some adjustment and assembly/disassembly operations require special tools and expertise; perform

these only if you have the skills to do so, otherwise consult your authorised dealer or a specialist.

•The symbol indicates the tools you will need to carry out adjustments.

•Your e-bike has a serial number engraved on the frame by the fork.

MAXIMUM LOAD:100 KG.FOR YOUR SAFETY IT SHOULD NOT EXCEED THE MAXIMUM LOAD WHEN USING

YOUR BICYCLE.

Battery

Electric motor

Pedal

sensor

Rack

(max load 25 kg)

Controller

Serial number

Display

Manuel PLIMOA

2- ADJUSTMENTS / ASSEMBLY

2.1 Adjusting the saddle:

6mm Allen Key

2.1.1 Angle:

Loosen the nut under the saddle.

Adjust the angle of the saddle in order to find your most comfortable position. Tighten the nut, with a maximum

tightening torque of 13 Nm.

2.1.2 Height:

The electric bike allows a lower seat position than on a conventional bike. With electric assistance you provide

less effort and you can sit down for improved safety. The required user (cyclist) height for optimal bicycle use

is between 1.50 and 1.85 m. Adjust your saddle height to the optimal sitting position as follows:

Loosen the quick release:

Wearing suitable cycling shoes, sit on the saddle, place one of the pedals in the lowest position, rest one heel

on the pedal, and your leg should rest normally on the pedal without being stretched. Raise or lower the

saddle to get the correct height. While pedalling backwards, you should not have to move your hips from side

to side.

Tighten the quick release.

The seat tube should not come out beyond the etched safety mark (vertical bars).

Security mark

Nut

Quick

release

Manuel PLIMOA

2.2 Handlebar adjustment:

Allen key 5 mm

To be comfortable, the position of your handlebars must be at least at the same height as your saddle, or more

depending on your comfort. Loosen quick release and set the desired height of your handlebars. Please do not

force as this may damage the various cables connected to the handlebars.

Make sure to tighten the quick release before you use your bike.

For tilt adjustment, use an Allen key to loosen the 2 screws of the bracket.

After adjustment, tighten the screws rotating in the direction of clockwise (tightening torque max: 11-12 Nm).

Quick release

2 adjusting screws

handlebar tilt

Manuel PLIMOA

2.3 Brake adjustment:

5mm Allen Key

Screwdriver

2.3.1 V-type front brake:

The front brake is operated by the left lever on the handlebar.

Completely tighten the nut on the brake lever, this feature will allow you to compensate later for the natural

slakening of the brake cable.

Loosen the cable clamp and pull the cable until the pads are pushed against the rim. Tighten the cable clamp

(particular attention is to be made to each end of the sheath which is to enter without forcing into the housing

of each rigid end side brake lever and V-Brake).

The pads are properly adjusted when they are in equal distance from the rim. The final adjustment is done by

tightening the screws mounted on the support pads with a screwdriver (distance of about 0.1 to0.5 mm of the

rim).

Your setting is correct when the wheel turning freely, stops suddenly.

Manuel PLIMOA

2.3.2 Rear V-type brake:

The rear brake is operated by the right handle on the handlebars.

AS with the front brake (Cf 2.3.1) fully tighten the nut on the brake lever, this feature will allow you

to later compensate the natural release of the brake cable.

Loosen the cable clamp (Cf: brake adjustment of pictures before) and pull the cable until the pads

are pushed against the rim.

Tighten the cable clamp (particular attention is to be made to each end of the sheath which is to enter without

forcing it into the housing of each rigid end side brake lever and V-Brake).

The pads are properly adjusted when they are in equal distance from the rim. The final adjustment is done by

tightening the screws mounted on the supports’pads with a screwdriver (distance of about 0.1 to0.5 mm of the

rim).

Warning! in the rain or on a wet surface, the braking distance increases.

2.4 Luggage rack:

Do not load your rack beyond the stipulated weight: 25 kg.

Any carrying device or other equipment installed by you on your rack (e.g., child seats, other equipment, etc.)

must be compatible with the robustness and build of the bike.

You must periodically check the tightness of the rack’s fastenings. This type of luggage carrier

is not designed to tow trailers.

Any alterations made to the rack by the user will at their own risk.

When the rack is loaded, changes in the behaviour of the bicycle must be taken into account (wind stability,

braking distances, changes in direction, etc.). For their safety, the user must be aware of these changes in

operation.

When installing a child seat or panniers, the user must perform a safety check (e.g., hanging straps that are in

danger of catching in the spokes and raise the risk of a fall; check the secureness of the fastenings on the child

seat, the potential trapping of the child's fingers under the saddle, etc.)

The reflector and the rear light must not be covered by the equipment or seat that has been fitted to the rack.

The load on the rack must be evenly distributed on both sides to ensure the stability of the equipment while

riding on public roads.

Manuel PLIMOA

2.5 Mounting and dismounting wheels (rear wheels by specialist):

2.5.1 Front wheel:

Wrench 15 mm

Removing the front wheel:

First, loosen the V-Brake’s cable clamp to release the pads and enable the removal of the wheel. Undo the cap

nuts on each side and remove the washers.

Lift the bike and lightly tap the top of the tyre to remove the wheel.

Replacing the front wheel:

Reposition the washers on the wheel axle. Lift the bike and insert the wheel axle into the base of the opening

of the fork ends.

Check the position of the washers as well as the centring of the wheel. Screw in the wheel nuts. Alternately and

progressively tighten the wheel nuts on each side (max. tightening torque 25 Nm).

If the wheel is not centred, loosen the nuts and start again.

Do not adjust the locknuts, you risk damaging the bearings.

Readjust your brake (see 2.3.1).

2.5.2 Rear wheel:

This operation should be performed by a professional, but here's what to do

15 mm open-ended spanner.

Removing the rear wheel:

Disconnect the motor (the connector is situated on the right side of the e-bike on the lower horizontal section

of the frame).

Cut the cable tie attaching the motor cable to the frame. Remove the right and left wheel nut covers. Loosen

the nuts. Remove the nuts and the wheel axel washers. Loosen the V-Brake’s cable clamp to release the pads

and enable the removal of the wheel.

Remove the chain from the wheel sprocket, while paying attention to how the chain swings.

Manuel PLIMOA

Replacing the rear wheel:

Take the wheel and place the chain on the small sprocket on the right-hand side, then place the wheel between

the brake pads.

Insert the wheel axle backward into the housing on the left and right of the frame. Attach the washers and the

wheel nuts. Tighten the nuts by hand initially, until they make contact with the frame.

Centre the wheel in line with the frame and the mudguard. Check the centring and positioning in line with the

front wheel, as well as the positioning of the chain.

Screw on the wheel nuts on both sides without tightening them. Check the positioning, centring and position of

the chain again.

Alternately and progressively tighten the wheel nuts on each side (max. tightening torque 30 Nm)

Replace the nut covers.

Reconnect the motor connection and replace the cable tie on the frame.

NB: the connector is equipped with a keyed connection. Place the two pins so that they are facing each other

(follow the arrows).

Adjust the brake pads (see 2.3.1).

2.6 Lights:

Your bike is equipped with:

❖Front and back fixed lighting. Both front and rear lamps are powered by the battery.

Position the two

pins correctly to

reconnect the

motor plug

Manuel PLIMOA

❖The lights are activated by pressing and holding the "+" button.

Always keep your lights and in good condition.

Lights are mandatory at nightfall.

2.7 Folding the Ebike:

The folding your electric bike is done in 5 steps:

•Lower the handlebars

•Fold the pedals

•Fold the stand

•Fold the frame

•Fold the stem

Otros manuales para PLIMOA

Tabla de contenidos

Otros manuales de Bicicleta de neomouv

neomouv

neomouv Bricks Manual de usuario

neomouv

neomouv DRIVE Manual de usuario

neomouv

neomouv CRONOS Manual de usuario

neomouv

neomouv CARLINA Manual de usuario

neomouv

neomouv PLIMOA Manual de usuario

neomouv

neomouv PLIMOA Manual de usuario

neomouv

neomouv CROONY Manual de usuario

neomouv

neomouv FACELIA N3 Manual de usuario

neomouv

neomouv FURTIVOO Manual de usuario

neomouv

neomouv ENARA Manual de usuario

neomouv

neomouv Montana Brose Manual de usuario

Manuales populares de Bicicleta de otras marcas

RAMBO

RAMBO R1000X2M-FF-BFD Manual de usuario

Vermeiren

Vermeiren SAFARI Manual de usuario

Velec

Velec A2/36V Manual de usuario

Coswheel

Coswheel A-ONE Manual de usuario

Betzold

Betzold 97869 Manual de usuario

Cervélo

Cervélo S3 2019 Manual de usuario

Tenways

Tenways AGO X Manual de usuario

Festo

Festo EGSC-BS-KF Manual de lista de piezas

Gio Electric

Gio Electric H1 Volt Manual de usuario

GOGOBEST

GOGOBEST GM30 Manual de usuario

DAHON

DAHON CIAO - 2009 Manual de usuario

Aprimatic

Aprimatic ONDA 500 Guía de inicio rápido

MV Agusta

MV Agusta Lucky Explorer GRAVEL Manual de instrucciones

Greyp

Greyp G6 Series Manual de usuario

Babboe

Babboe Carve-E Manual de usuario

Huka

Huka orthros Manual de usuario

Xtracycle

Xtracycle Stoker 2021 Manual de usuario

APRILIA

APRILIA DORSODURO 750 ABS 2015 Manual de usuario