Nemesis Hydra Air Manual V1.3
nemesisuvc.com | (469)-466-2UVC | Version 1.3
The airflow vents must remain unobstructed to allow for the best possible operating conditions
and to ensure the longevity of your device.
Disconnect the device from power source before cleaning the device or replacing radiators
(see page 24 for detailed instructions)
There are no serviceable parts inside the unit. DO NOT attempt to do any repairs beyond
basic cleaning and lamp replacement. Any attempts to repair the unit will void the
warranty. Nemesis is not responsible for any damages or harm caused by your repairs. Please
contact Nemesis at: (972) 423-0075 for repair assistance.
WARNING: To guard against injury, basic safety precautions should be observed, including the
following:
1. Read and save all notices, warnings and safety instructions received with equipment.
2. Avoid exposure to direct or reflected germicidal ultraviolet rays. Germicidal ultraviolet
rays are harmful to the eyes and skin.
3. Always disconnect power to the equipment and unplug before performing any service
or maintenance.
4. Do not operate without proper electrical ground.
5. To prevent the risk of severe or fatal electrical shock, special precautions must be
taken.
6. Equipment is intended for indoor use only.
7. Do not alter the construction or design. Do not remove safety labels or devices
8. Do not use equipment for other than its intended purpose, as described in the
equipment manual.
9. Keep inlet and outlet vents, clean and clear of objects.
10. Over time germicidal ultraviolet rays may break down plastic, rubber, or other non-
metallic materials, can fade colors, and can be damaging to plant life. Shield all plastic,
rubber, or other non-metallic parts, plant life, etc. which may be exposed to direct or
reflected germicidal ultraviolet rays.
11. Do not operate equipment if the power cord and/or plug are damaged, or if any other
damage to the unit is visible or suspected.
12. Utility power must match power requirements listed on the unit label.
