Nebula Capsule II Manual de usuario
Nebula Capsule Ⅱ
User Manual
1 Safety Instructions
Read all instructions before you use this device. Do not make any changes or create settings that are not
described in this manual. If physical injury, loss of data or damage is caused by failure to follow
instructions, the warranty does not apply.
Setup
● To reduce the risk of fire and/or electric shock, do not expose the device to rain or moisture.
Objects filled with liquids, such as vases, should not be placed on this device.
● Do not place this device on soft surfaces such as tablecloths or carpets, otherwise the device
could be a fire hazard.
● Do not place this device in areas susceptible to excessive dust and dirt or near any appliance
generating a strong magnetic field.
● To prevent overheating, do not block or clog the ventilation openings.
● Never place this device in a confined space. Always leave enough space around this device for
ventilation.
● Protect this device from overexposure to direct sunlight, heat, large temperature fluctuations and
moisture. Avoid extreme temperatures. The suitable operations and storage temperature for this
device and its accessories is 0°F to 95°F/ 0°C to 35°C.
● When this device is running for a long period of time, the surface may become hot. Shut it down
immediately and unplug the charger. Resume operation after this device has cooled down.
● Always handle this device with care. Avoid touching the lens. Do not allow children to handle the
device without supervision.
● Never place heavy or sharp objects on this device.
● To avoid electric shock, do not disassemble.
● Use attachments or accessories specified by the manufacturer only.
● Avoid extreme vibrations as they may damage the internal components.
Hearing Safety
● To prevent hearing damage, do not listen for extended periods at high volume. Set the volume to
a safe level.
Charging
● The charger type is an A2014 with output voltage/current of DC 15V/2A. The plug comes as a
separate piece from the adaptor. The charger should be installed near this product and should be
easily accessible.
● This charger is for indoor use only.
● When charging, place this device in an environment that has a normal room temperature (ranges
from 5°C to 25°C/ 41°F to 77°F recommended) and good ventilation.
● Due to the enclosure material used, this device shall only be connected to a USB interface of
version 2.0 or higher. The connection to so called power USB is prohibited.
Battery
● Do not replace the built-in battery yourself. Contact an authorized service center to replace it.
● Risk of explosion! Keep batteries away from heat, direct sunlight, or fire. Never dispose of
batteries by burning.
● Batteries contain chemical substances and they should be disposed of properly.
● Charge this device regularly. Do not store this device with a completely discharged battery.
● The remote control comes with two AAA batteries, which can be swallowed. Keep the remote
control out of reach of children.
● Remove the battery when the remote control will not be used for a long period of time.
● Replace the remote control battery only with the same or an equivalent type.
Cleaning
● Use a soft, lint-free cloth. Never use liquid, gaseous or easily flammable cleansers to clean.
● Do not use any liquid cleaning agents to clean the lens to avoid damaging the coating film on
the lens. Use lens cleaning paper to clean the lens.
Repairs
● Do not make any repairs to this device yourself. Only have your device repaired by an authorized
service center.
● Improper maintenance can result in injuries or damage to this device.
● Refer all servicing to qualified service personnel.
Caution
● Possible hazardous optical radiation emitted from this device.
● Do not stare at the operating beam. The bright light may damage your eyes.
2 What’s Included
3 Overview
————————————————
Front View
① Lens
② Air ventilation (inlet)
————————————————
Rear View
① Air ventilation (outlet)
② Infrared receiver
③ Power button
● Press and hold for 2 seconds to power on/off.
④ Speaker
⑤ USB-C port
● Connect to power supply (with supplied cable)
⑥ USB port
● Connect to a USB flash drive
⑦ HDMI input port
● Connect to a playback device
⑧ AUX-out socket
⑨
● Press to switch between Bluetooth speaker mode and projector mode.
● Bluetooth speaker power on/off
————————————————
Top View
① Volume up/down
② Confirmation button
③ Return button
④ Navigation buttons
● Touch to go to the next/previous page
————————————————
Bottom View
① Tripod socket
————————————————
Remote Control
① Power on/off button
② Microphone
③ LED indicator
④ Signal source switch button
● Press to switch between Android TV™ and HDMI interfaces
● Press and hold for 3 seconds to engage manual focus
⑤ Navigation buttons
● Navigate menus or adjust the selected contents
⑥ Confirmation button
● Press to confirm a selection or entry
● Pause / resume play
⑦ The Google Assistant button
● Press to talk to the Google Assistant（can be used only after Bluetooth pairing is successful)
⑧ Home button
● Press to access the home menu
⑨ Return button
● Return to the previous menu
⑩ Volume up/down button
LED Indication
LED Status
Description
Solid white
Operating in projector mode.
Flashing blue
Ready to pair/Bluetooth pairing (Bluetooth speaker mode).
Solid blue
Bluetooth connected (Bluetooth speaker mode).
Flashing red
Low battery
Solid red
Charging
Solid green
Fully charged
4 Getting Started
————————————————
4.1 Placement
Place this device on a stable, flat surface, and squarely point it to face the projection surface. For best
results, the projection surface should be white and flat. The distance between this device and the
projection surface must be a minimum of 23 inches (0.58 meters) and a maximum of 121 inches (3.08
meters) to get a projection image from 20 to 100 inches.
● It is unnecessary to tilt it towards the projection surface. You can correct the projection
image with the built-in keystone correction.
● The distance between the device and the projection surface determines the projection
image size. For the best result, set the projector between 40 and 80 inches away.
————————————————
4.2 Prepare the Remote Control
The remote control comes with two AAA batteries.
① For first time use, slide to open the battery compartment, and install two AAA batteries.
② To replace the battery, unlock and open the battery compartment, insert a new battery matching the
polarity (+/-) as indicated, and then close and lock the battery compartment.
————————————————
4.3 Get Started
① Fully charge the built-in battery before using for the first time by using the provided cable and charger.
② Hold on the projector for 2 seconds to turn it on.
③ Angle the device towards a suitable projection surface or wall.
④ To focus the image, slightly move the projector to engage auto-focus. Or you can press and hold
for 3 seconds to manually adjust the focus.
⑤ For first time use, follow the on-screen instructions to complete the basic set-up.
To give your Nebula CapsuleⅡ the fastest, safest charge, use the supplied charger only.
————————————————
4.4 Nebula App
To easily control this device, we recommend you to download the dedicated Nebula app, Nebula
Connect. By using this app, you can use the screen as a mouse.
① Download the Nebula Connect app from the App Store (iOS devices) or Google Play (Android
devices).
② Enable Wi-Fi on your smartphone and select [Nebula Capsule Ⅱ] as the device to be connected.
Note: Make sure your phone and Nebula Capsule Ⅱ are connected to the same Wi-Fi network.
③ Open the Nebula Connect app and follow the on-screen instructions to complete connection setup.
5 Powering the Nebula Capsule II with Android TV™
Follow the on-screen instructions to complete the setup process.
Option 1. Quick setup
Android phone users can follow the instructions to quickly set up Android TV with your Android phone.
Option 2. Set up Nebula Capsule II
For iOS users, follow the instructions to complete the process.
① Skip the quick setup process.
② Connect Nebula Capsule II to the network.
③ Sign in with your Google account.
Your Nebula Capsule II will be powered by Android TV after finishing the setup process.
6 Settings
Go through the setup process when you turn on Nebula Capsule II for the first time.
————————————————
6.1 Network
This device can be connected to the Internet via a wireless (Wi-Fi) connection.
① Press to open the home menu, select [Settings] > [Network & Internet] and press .
② Follow the on-screen instructions to complete the network connection.
————————————————
6.2 Bluetooth
A. Bluetooth Speaker Mode
You can use Capsule Ⅱ as a standalone Bluetooth speaker.
① Press to switch to Bluetooth speaker mode.
② Enable Bluetooth on your smartphone and select [CapsuleⅡ] as the device to be connected.
Note: Before using this projector as a standalone speaker, make sure the remote control is connected to
this projector via Bluetooth.
B. Projector Mode
You can connect Bluetooth headphones or a speaker to Capsule Ⅱ while in projector mode.
① Press to access the home menu, select [Settings] > [Remotes & Accessories] and press .
② Select Add accessories.
➢This projector will begin searching for accessories.
③ Press and hold and volume - button on the remote control simultaneously to enter Bluetooth
pairing mode.
④ Follow the on-screen instructions to complete the Bluetooth connection.
Note: Before pairing your Bluetooth devices, make sure they are in pairing mode.
————————————————
6.3 Projector
Press to access the home menu, select [Settings] > [Projector Settings], and press .
[Image mode]
[Auto] / [Standard mode] / [Battery mode]
[Color temperature]
[Normal] / [Cool] / [Warm]
[Auto keystone correction]
Enable/disable auto keystone correction.
[Auto focus correction]
Enable/disable auto focus correction.
Otros manuales para Capsule II
2
Tabla de contenidos
Otros manuales de Proyector de Nebula
Nebula
Nebula Prizm II Manual de usuario
Nebula
Nebula Capsule Manual de usuario
Nebula
Nebula Capsule II Manual de usuario
Nebula
Nebula Capsule Manual de usuario
Nebula
Nebula Mars II Pro Manual de usuario
Nebula
Nebula Mars II Manual de usuario
Nebula
Nebula Capsule II Manual de usuario
Nebula
Nebula Mars II Manual de usuario
Nebula
Nebula Solar Manual de usuario
Nebula
Nebula Capsule D4111 Manual de usuario
