Nanoptix ULTRA SYSTEM Manual de usuario
Owner’s Manual
First Edition – April 18, 2017
Last Revised – April 23, 2020
Document # 700075-0000R
Document # 700075-0000R
April 23, 2020
ii
WIRELESS ULTRA SYSTEM
OWNER’s Manual
Legal Notices
Disclaimer
Information in this document is subject to change without notice. Consult your Nanoptix Inc. sales
representative for information that is applicable and current. Nanoptix Inc. reserves the right to
improve products as new technology, components, software, and firmware become available.
No part of this document may be reproduced or transmitted in any form or by any means,
electronic or mechanical, for any purpose without the express written permission of Nanoptix Inc.
Copyright
Copyright 2020 by Nanoptix Inc.
Dieppe, New Brunswick Canada
All rights reserved
Printed in Canada
Confidential, Unpublished
Property of Nanoptix Inc.
Trademarks
Nanoptix is a trademark.
Other trademarks and registered trademarks are the property of their respective holders.
Federal Communications Commission (FCC)
Radio Frequency Interference Statement
Warning
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own
expense.
Document # 700075-0000R
April 23, 2020
iii
WIRELESS ULTRA SYSTEM
OWNER’s Manual
Information to the User
This equipment must be installed and used in strict accordance with the manufacturer's
instructions. However, there is no guarantee that interference to radio communications will not
occur in a particular commercial installation. If this equipment does cause interference, which can
be determined by turning the equipment off and on, the user is encouraged to contact Nanoptix
Inc. immediately.
Nanoptix Inc. is not responsible for any radio or television interference caused by unauthorized
modification of this equipment or the substitution or attachment of connecting cables and
equipment other than those specified by Nanoptix Inc. The correction of interferences caused by
such unauthorized modification, substitution or attachment will be the responsibility of the user.
In order to ensure compliance with the Product Safety, FCC and CE marking requirements, you
must use the power supply, power cord, and interface cables, which were shipped with this
product or which meet the following parameters:
Power Supply
UL Listed power supply with standard 60Hz-50Hz, 100-240VAC input and 12VDC isolated output
for the Game Interfaces, 24VDC output for the Spill Proof printer. Power supplies used must be
equipped with AC line filtering, over-current and short-circuit protection. The use of these
products with a power supply other than a Nanoptix Inc. approved one will require you to test the
power supply with the Nanoptix Inc. product for FCC and CE mark certification.
Communication Interface Cable
An approved Nanoptix interface cable must be used with this product. Use of a cable other than
Nanoptix approved product will require that you test the cable with the Nanoptix Inc. printer and
your system for FCC and CE mark certification.
Power Cord
A UL listed, detachable power cord must be used. A power cord with Type SVT marking must be
used. For applications outside North America, power cords that meet the particular country’s
certification and application requirements should be used.
The use of a power cord other than described here may result in a violation of safety certifications
that is in force in the country of use.
Industry Canada (IC)
Radio Frequency Interference Statement
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le
matériel brouilleur du Canada.
NOTE: Information contained in this manual applies to the following
firmware versions:
Controller Box - Host: 1.0O
Controller Box - Game: 1.0K
Spill Proof Printer: 5.64A
Zigbee Module: 4060
Document # 700075-0000R
April 23, 2020
iv
WIRELESS ULTRA SYSTEM
OWNER’s Manual
Table of Contents
Table of Contents.......................................................................................................... iv
About the Wireless Ultra System................................................................................... 1
Game Interface General specifications ................................................................................... 1
Spill Proof Printer General Specifications .............................................................................. 2
1Description of the Wireless Ultra System.................................................................. 3
1.1Game Interface configured as “HOST” ..................................................................... 4
1.2Game Interface configured as “GAME” .................................................................... 4
1.3Digi Xbee Wireless Module ......................................................................................... 5
1.4Spill Proof Printer ........................................................................................................ 5
1.5Control Box ................................................................................................................... 6
1.5.1Control Box Operation ........................................................................................................... 6
2Meters......................................................................................................................... 7
3Configuration and Setup ........................................................................................... 8
4DIP Switch Settings ................................................................................................. 10
5Communication Ports.............................................................................................. 11
5.1Spill Proof Serial RS-232 Port - 9 pin DB9 .............................................................. 11
5.2Game Interface (HOST) – Molex 10 pin Receptacle ............................................... 11
5.3Game Interface (GAME) – Molex 4 pin Receptacle ............................................... 11
5.4Game Interface (GAME) – Molex 6 pin Receptacle ............................................... 11
6Ordering Miscellaneous Supplies............................................................................ 12
7Troubleshooting....................................................................................................... 13
7.1Factory reset ............................................................................................................... 13
7.2Testing the Ultra Wireless System ............................................................................ 13
7.2.1LED Status ............................................................................................................................ 13
7.2.2Power on information ticket ................................................................................................. 13
7.3Testing the Spill Proof Printer .................................................................................. 14
7.3.1LED Status ............................................................................................................................ 14
7.3.2Power on information ticket ................................................................................................. 14
8Maintenance & Cleaning Instructions.................................................................... 15
9Access Accounting Information Remotely.............................................................. 15
10Service & Support................................................................................................ 15
Document # 700075-0000R
April 23, 2020
v
WIRELESS ULTRA SYSTEM
OWNER’s Manual
Figures
FIGURE 1: WIRELESS ULTRA SYSTEM ......................................................... 3
FIGURE 2: GAME INTERFACE – “HOST” ..................................................... 4
FIGURE 3: GAME INTERFACE – “GAME” ..................................................... 4
FIGURE 4: SPILL PROOF PRINTER ............................................................... 5
FIGURE 5: CONTROL BOX ........................................................................... 6
FIGURE 6: WIRELESS ULTRA SYSTEM ......................................................... 8
FIGURE 7: DIP SWITCHES ......................................................................... 10
FIGURE 8: GAME INTERFACE LEDS ........................................................... 13
FIGURE 9: POWER ON TICKET .................................................................. 13
FIGURE 10: POWER ON TICKET ................................................................ 14
Tables
TABLE 1: GAME INTERFACE SPECIFICATIONS .............................................. 1
TABLE 2: SPILL PROOF PRINTER SPECIFICATION ......................................... 2
TABLE 3: 9 PIN RS232 SERIAL INTERFACE ............................................... 11
TABLE 4: 10 PIN GAME TERMINAL INTERFACE(S) ....................................... 11
TABLE 5: 4 PIN GAME TERMINAL INTERFACE(S) ......................................... 11
TABLE 6: 6 PIN GAME TERMINAL INTERFACE(S) ......................................... 11
TABLE 7: POWER SUPPLY PART NUMBERS ................................................ 12
TABLE 8: CABLES AND CONSUMABLES ..................................................... 12
TABLE 9: MISCELLANEOUS PARTS ............................................................ 12
TABLE 10: GAME INTERFACE LED STATUS................................................ 13
TABLE 11: SPILL PROOF PRINTER LED STATUS ......................................... 14
Document # 700005-0000R
April 3, 2019
1
WIRELESS ULTRA SYSTEM
OWNER’s Manual
About the Wireless Ultra System
Game Interface General specifications
Operating Temperature -40°C to +85°C
Operating Relative Humidity 5% to 90% RH at 50C (non-condensing)
Communication 2.4GHz OQPSK with DSSS
Range 200 ft (60m), PRO 300 ft (90m)
Communication Interface RS-232C
Transmit Power 3.1mW (+5dBm), PRO 63mW (+18dBm)
Frequency Band ISM 2.4 GHz
Channels 16 Channels
Security 128-bit AES
Emission Standards United States - FCC Part 15 Subpart B
Canada - Industry Canada ICES-003
Europe – EN 55022
Class A emissions
Immunity Standards EN55024
Table 1: Game Interface Specifications
Document # 700005-0000R
April 3, 2019
2
WIRELESS ULTRA SYSTEM
OWNER’s Manual
Spill Proof Printer General Specifications
Print Method Direct Thermal
Resolution 8 dot/mm (203 dpi)
Print Width 80mm
Paper Width 80mm or 82.5 mm
Max Roll Diameter 82.5mm
Operating Temperature 0 to 50 C
Storage Temperature -40 C to +65 C
Operating Relative Humidity 5% to 90% RH at 50C (non-condensing)
Communication Interface Options USB and RS-232C, optional RS-485
Optional Interface Cash Drawer Kick Out
Memory/Firmware 64 Mbit of RAM, 16 Mbit of flash
Resident Character Sets Arial Bold (6 sizes)
Note: Other Character sets can be
pro
g
rammed quickl
y
Integrated Bar Codes UPC-A, UPC-E, interleaved 2 of 5, Code 39,
Code 128, EAN 8, EAN 13.
Speed Up to 125 mm/second
Sensors Paper out
Door open
Top of form
(
optional
)
Human Interface Drop-in paper loading, status LED, paper feed
button
Dimensions 130mm width x 110mm height x 180mm depth
Weight 0.55 Kg
Agency Compliance Underwriters Laboratory - UL 60950
Safety of Information Technology Equipment,
includin
g
Electrical Business Equipment
Canadian Standards Association - CSA 22.2
No. 60950
Safety of Information Technology Equipment,
includin
g
Electrical Business Equipment
TUV / VDE / GS Mark
Safety of Information Technology Equipment,
includin
g
Electrical Business Equipment
Underwriters Laboratories - IEC 60950 / EN
60950 CB Test Report and Certificate
Emission Standards United States - FCC Part 15 Subpart B
Canada - Industry Canada ICES-003
Europe – EN 55022
Class A emissions (Completer System)
Class B emissions
(
Spill Proof printer onl
y)
Table 2: Spill Proof Printer Specification
Document # 700005-0000R
April 3, 2019
3
WIRELESS ULTRA SYSTEM
OWNER’s Manual
1 Description of the Wireless Ultra System
The Wireless Ultra System has been designed to manage small game rooms. With simple non-
intrusive connections, the system can be scaled up or down to adapted to different needs.
From remotely clearing credits and printing behind the counter, to acting as a complete
bookkeeping center.
Figure 1: Wireless Ultra System
A – Pulse Wires
B – Force Cashout
Wires
C – GAME - Game
Interface
D – Printer Cable
E – Spill Proof
Printer
F – HOST - Game
Interface
G – Control Box
Document # 700005-0000R
April 3, 2019
4
WIRELESS ULTRA SYSTEM
OWNER’s Manual
1.1 Game Interface configured as “HOST”
The HOST is the central controller of the system and functions as a hub between all
components. The HOST is connected to the control box via an RJ-12 connector. The printer
communicates with and provides power to the HOST via a 10 pin Molex connector. The
individual GAMES interfaces communicate with the HOST with a Digi International Xbee module
using Zigbee wireless communication (IEEE’s 802.15.4)
Figure 2: Game Interface – “HOST”
1.2 Game Interface configured as “GAME”
The GAMES are installed in each cabinet and communicate with the game board via 2 wire
harnesses. Once paired, the GAMES relay information to and from the HOST.
Figure 3: Game Interface – “GAME”
Document # 700005-0000R
April 3, 2019
5
WIRELESS ULTRA SYSTEM
OWNER’s Manual
1.3 Digi Xbee Wireless Module
The wireless capabilities of the system are provided by the Xbee transceiver utilizing the Zigbee
suite of short-range communication protocols. Each HOST and GAME box contain one and are
linked to each other automatically in a mesh network shortly after power-up. In a typical
installation, each box should be able to communicate up to 100 feet apart. If additional distance
is required, repeaters can be used to extend the range.
1.4 Spill Proof Printer
The Nanoptix Spill-Proof thermal printer is extremely fast, quiet, and very reliable. With thermal
printing technology, there is no ribbon cassette to change, and paper loading is extremely
simple. It is powered by a 24VDC power supply. It’s used for printing reports. It communicates
and provide power to the HOST game interface through the DB9 connector.
For more information on the Spill Proof printer, please refer to the Spill Proof printer manual
Figure 4: Spill Proof Printer
Otros manuales para ULTRA SYSTEM
1
Tabla de contenidos
Manuales populares de Sistema de micrófono de otras marcas
Sennheiser
Sennheiser Evolution Wireless Digital EW-DX EM 2 Manual de usuario
Alpha Technologies
Alpha Technologies RBMS Manual de usuario
SWIT Electronics Co.,LTD.
SWIT Electronics Co.,LTD. CW-S150 Manual de usuario
Shure
Shure UA844 Manual de usuario
Panasonic
Panasonic SHFX70 - DVD HOME THEATER WIRELESS SYSTEM Manual de usuario
Pyle
Pyle PDWM5000 Manual de usuario