Before usin your Smart Warmin Bowl, please ensure that
you read these instructions carefully. Please save these
instructions for future reference. This product is desined
for use with nanobébé bottles and breastmilk storae bas.
WARNING!
Failure to follow instructions may cause scaldin
•Always place the bottle or ba in the warmin bowl before
fillin the bowl with water.
•To preserve nutrients, never fill the bowl with boilin water.
•Never heat the bowl in a microwave,in an oven or on a stovetop.
•Before fillin the bowl with water, ensure that it is placed on
a flat surface such as a kitchen counter.
•Always check the temperature of milk before ivin your baby
a bottle, by lettin a few drops fall on your skin.
•The amount of time it takes cold milk to reach body
temperature varies with the quantity of milk and the
temperature of the water in the bowl.
USING THE BOWL TO DEFROST BREASTMILK BAGS
1. Ensure the storae ba you are about to defrost is tihtly
sealed by runnin your finer alon the double zipper.
2. Place the storae ba inside the warmer with the
zipper facin up.
3. Fill the warmer with lukewarm tap water.
4. Remove the ba from the warmer when the frozen
breastmilk has completely thawed. (The time it takes
depends on the temperature of both the milk and
the water).
5. If feedin immediately, transfer the milk to a
nanobébé bottle and warm the bottle to body
temperature. Thawed breastmilk can be stored in the
fride for up to 24 hours. Do not refreeze.
HOW TO USE YOUR SMART WARMING BOWL Note: Carefully remove the bottle from the warmer and check
the temperature of the milk by lettin a few drops fall on your
skin, the inside of your wrist for example. The milk should be
approximately at body temperature. If the milk has not reached
body temperature, return to step 1 and repeat the process.
Never use boilin water. Warm bottle in tap water with nipple/
teat ONLY. Never use travel & storae cap while warmin.
Bottle will naturally float upwards as the breastmilk beins to be
surrounded by water and the warmin process beins.
Place the bottle, with the
nipple/teat on, upon the
dome at the base of the
bowl to prevent any air
pockets.
Fill the bowl with
warm tap water.
Remove from water, check temperature, if further warmin
is needed return to step 1 and repeat the process, then enjoy
feedin your baby!
12
3
NEVER use boilin water
Warm bottle in warm tap water with nipple/teat ONLY
NEVER use travel & storae cap while warmin
Water level should not reach the nipple/teat rin
WARNING!
