NANO HUB BORA 250 Instrucciones de funcionamiento
1
BORA 250
User and Maintenance Manual
Manuale d’uso e manutenzione
REV.03 –01/07/2021
2
USA
UK
THANK YOU FOR CHOOSING THE
BORA 250
By purchasing the Air Sanitizer Device,
you demonstrate that you care about the
air quality of your environment,
showing respect for your health and the
health of those around you.
3
Disclaimer:
This document is the exclusive property of FuEl S.r.l. all rights
reserved. Any disclosure, reproduction or transfer of the
content to third parties is prohibited without the prior
authorization of the Company. FuEl S.r.l. disclaims any
responsibility for damage to persons or property due to
improper use of this product and failure to observe the
indications, warnings, instructions and precautions contained
in this user manual.
This user manual is provided only in paper format and must
always accompany the BORA 250 device.
BORA 250 is manufactured by:
FuEl S.r.l.
Via Rossini 7 -21020
Bodio Lomnago (VA) ITALY
e-mail: [email protected]
4
Summary
DISCLAIMER
1. GENERAL INFORMATION
1. Intended Use
2. Applied Regulation
3. Description
4. Symbology
5. General Warnings
6. Hazard Warnings
7. Composition and Accessories
2. INSTALLATION
1. Installation Method
2. Mammut Installation
3. Schuko Plug Installation
4. Electrical Connection
3. HOW TO USE
1. Control Panel
2. Device Operation
4. MAINTENANCE
1. Regular Maintenance –Dust Filter
Cleaning / Replacement
2. Extraordinary Maintenance
5. DISPOSAL
6. TECHNICAL FEATURES
7. TROUBLE SHOOTING
8. STORAGE
9. LABELS
1. Device Plate data
2. Symbols and Safety Labels
5
5
5
5
6
7
9
10
10
10
11
12
13
14
14
14
15
15
17
18
18
19
19
20
5
1 - GENERAL INFORMATION
1.1. Intended Use
The device is intended to be used in collective transportation vehicles. It is used to
reduce the potential presence of pathogens like bacteria, viruses and pollutants
including particles, VOC, NOX and odors. The intended use of the device is for
enclosed environments where prevention of potential air contamination is required.
The device does not perform a disinfection function of the air or the environment.
1.2. Applied Regulation
Directive (EU) 2014/35 (LVD) and Directive (EU) 2014/30 (EMC).
The device, in the configurations and variants presented, has been designed to
prevent the increments of the environment contamination due to contaminated air.
ATTENTION! the device is not intended for disinfection.
1.3. Description
BORA 250 is an air sanitization and purification device intended for indoor
environments. The device carries out the air sanitization and purification acting
during the air transit that crosses itself. The activity of sanitization and purification is
performed through the principle of photo-catalysis (based on WO3 photo-catalyzer)
and through the use of a support impregnated in a copper solution. BORA 250 does
not use any type of additional electrostatic filtration.
Thanks to the oxidation reactions and the products that derive from them by virtue
of the energizing activity resulting from the action of the catalyst, the air is sanitized
and purified by systematically eliminating the harmful agents present in it, such as:
▪Virus
▪SARS-CoV-2 (*)
▪Bacteria
▪Fungi
▪Molds
▪Volatile Organic Substances
▪Nitrogen Oxides
▪Bad odors
▪PM2,5 and PM10
(*): The inactivation of the infectious viral load SARS-CoV-2 was verified according
to tests performed at the viral pathogenesis and biosecurity laboratory of the San
Raffaele hospital in Milan. The test was performed in a liquid environment on a
circular shaped test object.
6
The device does not require the use of any type of biocidal chemical substance or
potentially harmful light sources and can therefore be operated safely in the
presence of people.
1.4. Symbology
Information requirement
This symbol identifies the presence of useful and general
information that alerts the user to a proper use of the device and
/or to the execution of specific actions.
Attention, refer to the user manual. Safety information.
Requirement for Proper Use
This symbol identifies information necessary for the correct use of
the device.
Possible electrical shock hazard.
Inappropriate use can cause injury or damage to the user.
Disconnect the power supply.
Keep away from flames or heat sources.
To make reading the manual comfortable and clear, the symbols used to manage
the important warnings for a correct and safe use of the device are shown below.
7
Keep away from moisture.
DO NOT Disassemble.
Indicates that the product is designed and manufactured according
to the essential safety requirements, in compliance with Directives
2014/35/UE (LVD) of the European Parliament and of the Council
of 26 February 2014 and 2014/30/UE (EMC) of the European
Parliament and of the Council of 26 February 2014.
1.5. General Warnings
Failure to comply with the warnings below as well as the rules and precautions
described in this user manual will result in the immediate forfeit of any warranty on
the BORA 250 device. FuEl S.r.l. is not responsible for any damage to persons or
property as a result of failure to comply with the rules or precautions listed below
and reported in this user manual.
FAILURES OR NEGLIGENCES IN FULFILLMENT OF THE
FOLLOWING INSTRUCTIONS MAY CAUSE DEVICE
MALFUNCTION, DAMAGE AND INJURY TO THE USER
DO NOT USE THE DEVICE UNTIL YOU HAVE READ AND
UNDERSTOOD EVERY DETAIL OF THIS USER MANUAL
NO MODIFICATION TO ANY PARTS OF THE DEVICE ARE
ALLOWED
THE USE OF THE DEVICE FOR PURPOSES OTHER THAN THOSE
INDICATED IN THIS USER MANUAL COULD EXPOSE THE USER
TO DANGER
8
▪This appliance is intended exclusively for use inside vehicles, cabins and
environments that are enclosed and sheltered from atmospheric agents. The
device can also be used in indoor environments such as shops, offices, hotels,
motels, bed & breakfasts, residential and similar enclosed spaces
▪Do not use the appliance outdoors, in areas with a high amount of dust or in
environments with extremely volatile materials that could clog the filters or
damage the motors
▪The appliance must be kept out of the reach of children
▪Make sure that the appliance does not come into contact with water or other
liquids
▪Do not obstruct the air passage grilles of the appliance with cloths, rags or
various similar objects during operation
▪Do not place device near furniture, furnishing accessories or walls that could
limit the air flow
▪Do not sit or lean on the product
▪Do not place objects on top of the product
▪Do not rest the product on unstable or inclined surfaces
▪Keep animals away from BORA and its power cable
▪Do not clean the surfaces of the product with petrol, thinners, chlorine or acid
detergents
▪This appliance is not a substitute for ventilation or cleaning equipment.
Therefore, it is recommended to keep the driver and passenger department
clean with vacuum cleaners or cleaning devices
▪Do not use BORA if it does not appear to be working properly. In this case, turn
off the appliance, disconnect the power supply and contact qualified personnel
9
1.6. Hazard Warnings
Do not insert any tools or fingers into the air
passage grilles.
Do not disassemble or remove components of
the appliance (the only exception is the filter tray
for regular maintenance of the dust filter).
Never immerse the plug, the electric cable,
the power supply and the appliance in water
or any other liquid.
Do not handle the plug or the device with wet
hands.
Do not use the appliance if flammable sprays,
insecticides or in places where oily residues or
chemical vapors are present.
Do not use the appliance in humid
environments, such as bathrooms, saunas,
tubs, sinks and swimming pools.
Keep away from heat sources such as
fireplaces, ovens, stoves and radiators.
Do not damage or tamper with the power
cord. It must be replaced by the manufacturer
or a qualified service technician in order to
prevent any risk.
10
COMPOSITION:
▪BORA 250 Device
Sanitizer
▪Remote Control for
vehicle dashboard
▪This "User and
Maintenance Manual"
1.7. Composition and Accessories
THE USE OF ELEMENTS THAT ARE NOT PART OF THE DEVICE
OR NOT SUPPLIED WITH THE DEVICE COULD AFFECT SAFETY
AND EFFECTIVENESS.
If you have not received all the items listed below, please
contact your dealer immediately.
2 - INSTALLATION
2.1. Installation Method
Open the package and remove the device by handling it on the sides. Open the
protective bag and remove the device, paying attention to the power cable.
THE INSTALLATION OF THE DEVICE MUST BE PERFORMED
ONLY BY MANUFACTURER’S TECHNICAL STAFF OR BY
ADEQUATELY QUALIFIED, SPECIALIZED AND TRAINED STAFF.
BEFORE PERFORMING THE INSTALLATION ALWAYS ENSURE
THAT THE BATTERY IS DISCONNECTED FROM VEHICLE'S
ELECTRICAL SYSTEM
THE ITEM IS INTENDED TO BE USED IN CLOSED
ENVIRONMENTS, THE ITEM MUST BE CONNECTED WITH THE
SUITABLE VOLTAGE (SEE THE "TECHNICAL FEATURES"
PARAGRAPH OF THIS MANUAL).
Tabla de contenidos
Idiomas:
