N-BIOTEK NB-101S Manual de usuario

ORBITAL SHAKER

MODEL : NB-101S

OPERATING MANUAL

www.n-biotek.com N-BIOTEK

NB-101S(Ver. 2014) 2/13

1. GENERAL INFORMATION ON PRECAUTION

●Precaution is to prevent the possible accident or danger during operation.

So, you must keep it.

●Precaution is separated into caution and warning. And, each of them means like this.

●Other marks

1.1 Precaution to connect the power cable

You have to use the product under specified electrical conditions.

(If you use the product at the place in different power pressure, it causes a fire and

malfunction of the product.)

Do not make the power plug be pressed by back of the product.

(A space between the product and the plug must be 20cm at least.)

The power outlet must be only for this product.

(Using various products simultaneously can cause a fire)

Clean the power plug with a dry towel and connect it properly.

(Foreign substances or unsafe connection can cause a fire.)

www.n-biotek.com N-BIOTEK

NB-101S(Ver. 2014) 3/13

Do not bend the power cable hardly and do not make it to be pressed by heavy products.

(When it is damaged, it can cause a fire.)

Do not touch the power code with wet hands.

(It can cause an electric shock.)

Do not use the damaged power code and outlet.

(It can cause an electric shock and a fire.

When you see smoke comes out from the product or smells something is burning or see

any other strange symptoms, you have to pull out the power code and stop using it.

(It can cause an electric shock and a fire.)

1.2.Precaution for installation

Use it with the proper voltage.

Please check the voltage & hertz written on serial label.

(Over-voltage, low-voltage can damage the product and poor performance.)

Do not install at a humid place.

(It causes an electric leakage accident and a corrosive of the product.)

Keep this product out of the direct ray of the sun and do not install at a hot place or a

place that is near an electric heat.

(The proper indoor temperature is 20℃~ 30℃)

Do not put inflammable substances near the product.

(It can cause a fire.)

When you install the product, you have to put the distance of more than 20cm

from the wall.

Install at a flat and solid ground.

(If the ground is not flat, it can cause a vibration of the product.)

www.n-biotek.com N-BIOTEK

NB-101S(Ver. 2014) 4/13

When you move the product, do not lay down to its side or reverse the head to bottom.

(It can cause the malfunction.)

When you move the product, hold the door and other movable parts of the product with a

tape. (When the product is moved, the movable door can cause injury of you and

damage of the product.)

When you move the product, you must hold up the product.

(Pushing or pulling the product can damage the bottom part of the product.)

1.3 Precaution for use

You must not disassemble, fix and remodel the product by yourself.

(You can damage the product throughout a fire and malfunction or get a property loss

from a different study result than the original purpose.)

Do not use the product for different purpose

(It can cause malfunction or poor function. Consequently, you will get a wrong result.)

Do not use an inflammable spray near the product.

(The switch and other electric connection parts can cause a fire.)

When you use inflammable substances such as benzene, thinner, alcohol and LP gas,

please be careful. (It can cause a fire and an explosion.)

To prevent water and experiment material from going into the control panel during the

experiment, make sure to clean the control panel with a dry cloth.

(It can cause an electric leakage and a fire.)

Do not wash the product with excessive quantity of water, thinner, benzene and

Petroleum. (It can cause an electric leakage, and malfunction or damage on the surface.)

When you don't use the product or clean it, please pull out the power plug.

(It is to prevent an eclectic leakage.)

www.n-biotek.com N-BIOTEK

NB-101S(Ver. 2014) 5/13

Open and close the door softly and please use a door knob.

(A heavy shock can damage the product and breakdown the operating part. Also your

hands can be stuck between the door and body.)

Do not detach the built-in lamp and electrical devices.

(It can cause an electric shock and a fire.)

1.4 Precaution for ground connection

Please ground before use the product, if you don't ground, you can get an electrocution

when malfunction or an electric leakage occurs.

At the place where you can't ground,

* Please buy the equipment to prevent any electrical leakage.

* An electric shock, an electric leakage and a fire can be occurred without an electric

leakage breaker.

Do not ground to these places; Gas Pipe, water pipe, pipe, lighting rod, telephone wire

etc.

* Wrong ground connection can cause electrical leakage which eventually results in

fire.

If you don't have the outlet for AC 220V, then bury it under the ground after connecting

the ground line to copper plate.

* No ground connection can bring an electrocution, an electric leakage and a Fire.

www.n-biotek.com N-BIOTEK

NB-101S(Ver. 2014) 6/13

2. FEATURE & SPECIFICATION

2.1 Feature

●Magnetic induction drive & Brush less DC motor provides less vibration and maintenance.

●Artificial intelligence system which maintains precise speed & adjust time.

●LED indicates temperature, speed, time and state of power failure.

●No heat generated during operation.

●Easy to change accessory platform.

2.2 Specification

www.n-biotek.com N-BIOTEK

NB-101S(Ver. 2014) 7/13

2.3 Configuration

Power switch

PLATFORM

CONTROL PANEL

2.4 Control panel

A B C D E

DISPLAY

For displaying RPM and TIME

RPM/TIME

Key for selecting RPM and TIME

SET

Key for saving desired RPM and TIME

UP, DOWN

Key for adjusting RPM and TIME value

START/STOP

START / STOP

www.n-biotek.com N-BIOTEK

NB-101S(Ver. 2014) 8/13

3. OPERATION

1) Turn the Power switch “ON”position on the rear of the shaker.

The digital readout will display as below.

2) Speed (RPM) Set-up

Press the “RPM/TIME” key approximately 1 or 2 seconds until LED blinks with current programmed

RPM. Don’t set RPM below 30.

In this input mode, adjust RPM as desired using UP(▲), DOWN(▼) key and press “SET” key finally to

save the adjusted RPM to be programmed.

* RPM setting range is from 30 to 300.

If you do not press the "SET" key to store the desired speed the new speed will not be saved and the

set speed will return to the prior setting

3) Time Set-up

3-1) Press the “RPM/TIME” key for the approximately 1 or 2 seconds until LED displayed

“t 00.00” as below.

3-2) Press the “SET” key. Then LED will display setting time and can be set the time using

UP(▲), DOWN(▼) key as desired set point time.

At first, you can set the hour using UP(▲), DOWN(▼) key and press “SET” key.

You can set the minute using UP(▲), DOWN(▼) key after set the hour.

Press “SET” key again after set time (hour and minute), then LED display as “t SAVE” as

below.

www.n-biotek.com N-BIOTEK

NB-101S(Ver. 2014) 9/13

* Time set point range is maximum 47 hr 59 min.

If you want to use this incubator continually, you must set value as 00:00.

When you set the time like above and operate instrument, -END- is displayed after a minutes.

But shaking is well running without stop till reaching desired time.

After pushing start button under time set-up, the instrument would be stopped with

displaying –END- when the time is reached at set time.

www.n-biotek.com N-BIOTEK

NB-101S(Ver. 2014) 10/13

4. Accessory description

NB101S with no accessory

101S-PL Universal platform

101S-SR Spring rack

101S-H10

100ml Flask Holder x 16ea

with 101S-PL

101S-H25

250ml Flask Holder x 9ea

with 101S-PL

101S-H50

500ml Flask Holder x 5ea

with 101S-PL

101S-H100

1000ml Flask Holder x 4ea

With 101S-PL

101M-M

Microplate Rack<6ea>

With 101S-PL

Tube rack + 101S-PL

101S-2S

2 Stairs

(4 Supporters with 101S-PL)

Tabla de contenidos

Otros manuales de Equipo de laboratorio de N-BIOTEK

N-BIOTEK

N-BIOTEK NB-204MR Manual de usuario

N-BIOTEK

N-BIOTEK NB-T101S Manual de usuario

N-BIOTEK

N-BIOTEK NB-203XXL Manual de usuario

N-BIOTEK

N-BIOTEK NB-101M Manual de usuario

N-BIOTEK

N-BIOTEK MINI-CELL NB-203M Manual de usuario

N-BIOTEK

N-BIOTEK NB203QR Manual de usuario

N-BIOTEK

N-BIOTEK NB-205 Manual de usuario

N-BIOTEK

N-BIOTEK NB504CIR Manual de usuario

N-BIOTEK

N-BIOTEK NB-201M Manual de usuario

N-BIOTEK

N-BIOTEK NB-205QM Manual de usuario

N-BIOTEK

N-BIOTEK NB-T101M Manual de usuario

N-BIOTEK

N-BIOTEK NB-205LF Manual de usuario

Manuales populares de Equipo de laboratorio de otras marcas

Qiagen

Qiagen DML 3000 Manual de usuario

Queensgate

Queensgate NANOSCAN OP400 Manual de programación

Conviron

Conviron GEN1000-GE Manual de usuario

Parr Instrument

Parr Instrument 4560 Manual de instrucciones

IKA

IKA IC control Manual de usuario

Integra

Integra DOSE IT Manual de usuario

Agilent Technologies

Agilent Technologies 5800 ICP-OES Manual de usuario

Endress+Hauser

Endress+Hauser Cleanfit CPA875 Manual de usuario

NI PXI-5422 Manual

Collomix

Collomix Aqix Manual de usuario

SPEX SamplePrep

SPEX SamplePrep 6875 Freezer/Mill Series Manual de usuario

Ocean Insight

Ocean Insight FLAME-NIR+ Manual de usuario

Parker

Parker ALIGN-MG-NA Manual de usuario

BD 644787 Manual de usuario

DENTAURUM

DENTAURUM Compact Megaplus Manual de usuario

Biuged Laboratory Instruments

Biuged Laboratory Instruments BGD 626 Manual de usuario

VWR

VWR SAS Super IAQ Manual de usuario

illumina

illumina MiSeqDx Manual de usuario