STEP 2; SEE FIGURE 4:
Install Brackets, Left and Right (1&2)
For 1990 to 2003 Economy Models
A. Remove the bolts at Reference N. Drill the
hole out to 5/16”.
B. Insert a 5/16” x 1 3/4” bolt inwards through
the lower hole in the Bracket and then the
handlebar. Add a locknut do not tighten at this
time.
C. Remove the carriage bolt at Reference P.
Insert a 5/16” x 1 3/4” bolt through the Bracket
and handlebar. Add a locknut. Do not tighten
at this time.
STEP 2; SEE FIGURE 5:
Install Brackets, Left and Right (1&2)
For 1985 to 1990 Models
A. Remove the carriage bolts at Reference Q.
Insert a 5/16” x 1 3/4” bolt through the Bracket
and handlebar. Add a locknut. Do not tighten
at this time.
B. Place the 1 1/4” U Clamp over the
handlebar open end forward. Insert a 5/16” x 1
3/4” bolt inwards through the clamp. Place the
lower hole of the Bracket over the bolt on the
inside of the handlebar. Add a nut. Do not
tighten at this time.
STEP 2; SEE FIGURE 6:
Install Brackets, Left and Right (1&2)
For Pre 1985 Models
A. Place the 1” U clamps against the top of the
control panel open end up. Insert 5/16” x 1
3/4” bolts inwards. Add locknuts. Do not
tighten at this time.
B. Place the 1” U Clamps open end pointed
down over the handlebar. Insert 5/16” x 1 3/4”
bolts inwards. Add locknuts. Do not tighten at
this time.
Figure 4 1990 to 2003 Economy Models
FIGURE 5 1985 to 1990 Models
FIGURE 6 Pre 1985 Models
5
