6
⑴Sample volume setting: Press “Select” button to adjust the cursor position, press
the “up” and “down” button to adjust to the desired sample volume, press "Exit" to
exit the settings, press "Menu" to enter the next parameter setting.
⑵Sampling delay time setting: Press “up” and “down” button to adjust to the desired
sampling delay time, press "Exit" to exit the settings, press the "Menu" to enter the
next parameter setting.
⑶Sampling location setting: Press “up” and “down” button to set the sampling point
code, press the "Exit" button to exit the setting, press the "Menu" to enter the next
parameter setting.
⑷Save sampling setting: Press “up” and “down” button to choose "Yes" and press
"Select" to save the current sampling parameters. Press "Exit" to return to the main
menu, setup is complete.
⑸Main menu will show the latest settings of the sampling parameters.
4. Detail function menu guidance:
When switched on, the display shows splash screen, and device automatically running
self-test, after self test, the device will enter the main interface. Then press “Menu”
button to enter parameter setting mode:
⑴Sample volume settings: In this state, press “Select” button to adjust the cursor
position, press the “up” and “down” button to adjust the sample volume in the range
of 10 to 6000 liters, adjusted in steps of 10 liters, press “Exit” to exit parameter setting,
press “Menu” to enter the next parameter setting.
⑵Sampling delay time setting: In this state, press “up” and “down” button to adjust
sampling delay time, the sampling delay time ranges from 0 to 256 seconds, adjusted
in steps of 1 second, press “Exit” to exit the parameter setting Press “Menu” to enter
the next parameter setting.
⑶Sampling location setting: In this state, press “up” and “down” button to set the
sampling location, coding ranges from 00 to 99, press “Exit” to exit the parameter
setting, press “Menu” to enter the next parameter setting.
⑷Save sampling settings: Press “up” and “down” button to choose whether to save
the current sampling parameters, press “Select” to save.
Note: When screen displays "Yes", pressing "Select" will save the settings.
When screen displays "No", pressing "Select" will not save the settings.
These three parameters (Sample volume, sampling delay time and sampling
location) when adjustment finished, you must go to the fourth item "Save to
apply the setting", select "Yes" to save, then new setting takes effect, if you
choose "No" related settings will not be saved.
⑸Delete sampling setting: Press “up” and “down” button to select whether to delete
the set sampling parameters, press "Select" will take effect.
