( Turn off the main power supply in the circuit breaker box,
before commencing the installations.)
1. Make wires connec�on according to the wiring instruction
in the rear page.
2. Remove the wall control front plate using a flat and small
screwdriver.
3. Mount the wall control unit onto wall outlet box with the
provided two screws firmly.
( Can be installed vertically or horizontally.)
4. Replace the front plate.
5. Replace the power supply; the wall control is now ready for
operation.
This is NOT a 360-degree rotate switch,
must turn counterclockwise 3-2-1-0
to switch the fan off
spiTlortnoCdeepSnaF-2petS
1. In case the fan is a pull chain Set the pull chain switch.
Keep in position "High speed" if your ceiling fan
Set the speed control switch.
2. You can now turn the knob clockwise.
To control the fan speed (respectively)
Turns off 0 fans
1 - 4 Adjust the fan speed. Chasing from low speed
To the high speed
7
Installa on of Transmi er
Wall Mount Holder with two
screws.
Ceiling fan Remote Control
Wiring Connection
Keep antenna safely inside canopy.
Make sure its wiring is not cut or damaged
1
2
3
4
5
6
1Hr 3Hr 6Hr
The function of the transmitier
ON / OFF: Turn the fan on or off.
Speed: Press bution 1-6 to select
speed level.
Off bution: Press the shutdown bution to
deactivate the fan.
Timer button: Press button 1,3, or 6 hours
to set the auto-off time atter starting
activation.
Light on / off button: Turn on the light,
press the top of the button. Turn off the
light by pressing the botton of the
8
