6
Weight
Dimensions 38*92*48mm
208g
Operation Voltage 3.7V
Battery Capacity 750mAh
Upgrade/Charging Port USB-C
Temperature 0--50℃
Specifications
Firmware Upgrading
The iFoucs handunit can be upgraded separately or together with the iFocus by
connecting via Multi-CAN cable.
Operating instructions
a. Turn off the handunit and follow focus motor.
b. Connect the handunit and follow focus via Multi-CAN cable, and connect the
handunit to the computer via Type-C cable.
c. Long press the power button on the follow focus for 3s until the white indicator
light is on.
d. Hold the top button and don’t release, then click the power button (hold the
top button and the power button at the same time) until “Boot Mode” pops up
on the screen, the handunit enters into the boot mode.
e. Launch the MOZA Master software, the software will automatically enter the
upgrade interface. After the firmware download is complete, click “upgrade”
button and wait about 30s.
f. During the upgrade, the screen will display ‘Upgrading’, after the upgrade is
complete, the screen will display ‘Upgrade Success’;
g. Restart the handunit and follow focus.
d)Handwheel calibration is successful (as shown)
e)Click the left button to return to the previous menu, and then click the menu
button to return to the main interface.
about >: Check firmware version information.
3. calibration co
mpleted !
Note:IFocus motor can be used with the handunit only when their firmware
can match. Please upgrade iFocus motor with wireless handunit together to
control the iFocus motor.
