5
.1 Attach the Shabbat mechanism to the ATTO
SPORT handlebar by tying the exible lead
around the central part of the handlebar
(Figure 9).
.2Operate the scooter by pushing “POWER” – the
main power button of the scooter. (Figure 11).
.3 Attach the USB cable to the socket located on
the handlebar under the screen (Figure 10).
.4 Check that the blue lamp on the Shabbat
mechanism is lit (Figure 5).
.5 Operate the Shabbat mechanism by pressing
on the standby-mode button (Figure 1), and
wait for a few seconds.
.6 After a few seconds, the word SHABT will
appear on the scooter’s display screen.
.7 The scooter will go into “Crawl Mode” and
move forwards and backwards at a very slow
speed in order to preserve continual energy
in the system.
.8 From this moment, the system is in Shabbat
mode and the buttons in Shabbat mechanism
work according to the principle of “Gramma“
(Indirect Operation).
.9 It is recommended that you set the speed
with the “+” button (Figure 3) in the Shabbat
mechanism before Shabbat commences.
With each push of the button, the speed limit
increases by 1 km/hour.
.10 The maximum speed for travel in the Shabbat
mode is up to 6km/hour. Pressing the “+”
button again after the 6km/hour speed limit
has been reached will return the speed limit to
1km/hour.
Important! In “extra–strict” mode, do not
operate any buttons except for the throttle
button, and therefore set the speed limit,
travel direction and light modes before
Shabbat commences.
Important note! In order to avoid a situation
where the scooter's battery is drained
prematurely, please fully charge it and operate
the Shabbat mechanism as close as possible to
the beginning of Shabbat.
OPERATING INSTRUCTIONS –
BEFORE SHABBAT COMMENCES
