monolith ZEUS001/PM Instrucciones de funcionamiento
FAUCETS FOR LARGE INSTALLATIONS
USER AND MAINTENANCE MANUAL
ZEUS001/PM
ELECTRONIC SINK TAP
PREMIUM LINE
POWERED BY BATTERY (4x1,5V AA)
WITH MECHANICAL PRE-MIXER
MONOLITH srl Thanks you to buy a product from our gamma and invites you to read this manual which contains all
the necessary information for a correct use of the item.
The user is required to reading the same before the use and to an use in accordance with the warnings contained in
it.
The User and Maintenance manual has to be available for a correct conservation.
MONOLITH srl reserves the right to make variations or changes to this manual without obligation to notice it to the
customers.
DESCRIPTION:
Electronic sink tap powered by LITHIUM batteries type AA 4x1,5V. Water distribution through activation of sensor
infrared fixed fire.
OPERATING:
The Infrared Sensor (C) (see pict. 1) recognizes the presence of the hands and begins to dispense water until it is
more present or until the maximum closing time elapses (ANTI VANDALIC SYSTEM).
If The system detects an object for about 1 minute, the system automatically closes the water supply until the
object is removed.
The battery exhaustion is indicated by the red flashing light of the LED, the solenoid valve closes and the dispensing
system stops waiting for the batteries to be replaced.
The operation of the faucet is guaranteed only with water without impurities.
Install the interception taps with filter (not supplied) in the line, to preserve the functionality
of the solenoid valve and for any maintenance operations.
Use only LITHIUM batteries for greater durability and efficiency of the product.
INSTALLATION INSTRUCTIONS:
Always bleed the piping before installation and at
every temporary closure of the system.
1) Close the water supply.
2) Pierce the sink ø33.
3) Manually Tighten the tie rod (2) to the base of the
already assembled tap (1). Insert The sealing base (3)
and O-Ring (4) into the already assembled tap (1).
4) Place the tap on the hole Ø 33 previously made in
the sink, passing the hose (5) and the cable (A) inside
it.
5) Fix the faucet to the sink by inserting under the
sink the shaped gasket (7) then the metal Insert (8)
and tighten the hexagonal nut (6) on the tie rod (2).
Use a clamping wrench SW11.
6) Connect the flexible (5) to the fitting (9).
7) Connect the mechanical pre-mixer (10) to the
fitting (9) after insert the gasket (11).
8) Connect the hoses (12) to the mechanical pre-
mixer (11).
9) Connect the hoses (5) to the water mains.
10)Fasten the battery holder box (B) to the wall
(under the sink) using the appropriate screws and
plugs (not supplied) after drilling the wall from ø6,
making sure that the cable outlet is facing
downwards as in pic. 1. Place the battery box in the
safe area away from possible damages.
11) Insert The 4 lithium batteries into the box making
sure that the + and-poles are correctly matched.
12) Connect the cable (A) to the battery holder box
(B)
13) The system is set by default as per product
specifications with a closing delay (comfort time) of 6
sec and a self-closing for blinding sensor (vandal
resistant) of 1 min.
1
2
4
3
5
ASW11
B
C
7
8
6
9
12
10
12
11
pic. 1
Important! The installation operations must be carried out by suitably trained personnel taking into account the
information given by this manual.
TECHNICAL INFORMATION:
POWER
LITHIUM BATTERY AA 4x1,5V
MIN/MAX PRESSURE OF USE
0,5÷8 bar (recommended 3 bar)
MAXIMUM TEMPERATURE OF USE
60°C
SENSOR DISTANCE
10 cm ± 2 cm
WATER FLOW
6 L/min con 3 bar of pressure
FLEXIBLE CONNEXION
G 1/2" Female
FLEXIBLE LENGTH
40 cm
NON RETURN VALVE
Included
LOW BATTERY SIGNAL
yes
ANTI VANDALIC SYSTEM
yes
MAIN DATA SYSTEM
Field sesitivity
100mm ± 20mm (Non-adjustable)
Auto-closing valve
The ignition, avoiding water escaping.
Maximum opening delay
400msec (depending on the pressure)
Closure delay (Comfort time)
Standard: ~6 sec ± 1 sec
Auto-closure for blinding sensor (Antivaldalic)
Standard: ~1min
Anti-legionella distribution
Automatic Operation after 24 hours of Unuse
Tensione delle batterie sotto 5,2Vdc
The system not allows the valve’s opening
RED Led for low battery status signal. For each action on user request, if the battery is no longer able to activate the valve, the LED flashes.
LED on fixed at start to show the correct connection. At each opening and closing control valve a short flashing of the LED. In case of
almost discharged batteries, indication with 3 flashes. In case of exhausted batteries indication with 6 flashes.
Reverse polarity Protection.
Algorithmic Correction of sensor response to the sudden variation of ambient temperature.
The sensor is equipped with a system of minimization of electromagnetic disturbances.
4,5
50
18
51
64
84
~320
O40,5
WARNINGS:
-For use with water only
-Only for indoor use
-Do not use toxic or abrasive products to clean the faucet
MAINTENANCE:
Important! Any maintenance operation must be carried out by suitably trained personnel taking into account the
information given by this manual.
Periodically Wipe the sensor with a mild damp cloth.
Periodically Clean the filter of the shut-off tap in the supply line.
DISPOSAL OF POLLUTING MATERIAL:
In case of maintenance or demolition of the product, the parts of which it is composed must be entrusted to
companies specialized in the disposal and recycling of industrial waste, in transposition of the European Directive
2012/19/EU (WEEE) concerning the disposal Electrical and electronic equipment and, in particular:
-DISPOSAL OF THE PACKAGING:
The packaging consists of biodegradable cardboard that can be delivered to companies for the normal recovery of
cellulose.
-DISPOSAL OF METAL PARTS:
The metallic parts are recoverable from the companies specialized in the metal scrapping sector.
MAIN DATA BATTERY HOLDER
Supported batteries
4 lithium primary batteries type AA 1,5V
Protection class
IPX5
-DISPOSAL OF FURTHER PARTS:
Further parts such as pipes, rubber seals, plastic parts, electrical and electronic parts are to be entrusted to
companies specialized in the disposal of industrial waste.
WARRANTY:
The duration of the warranty lasts 24 months from the date of purchase.
Any tampering or modifications to the product will invalidate any warranty request from the Customer.
All parts which may be defective due to failure to observe the operating instructions, incorrect installation or
maintenance, maintenance operations carried out by unauthorized personnel, transport damages, are Not covered
by warranty, or circumstances which, however, cannot be traced back to manufacturing defects.
The manufacturer declines all responsibility for any damage that may, directly or indirectly, result in persons and/or
things as a result of failure to comply with all the prescriptions indicated in the following Instruction Manual and
concerning, Especially, the warnings regarding installation, use and maintenance.
FAILURE TO COMPLY WITH THE INSTRUCTIONS CONTAINED IN THIS
BOOKLET IMPLIES THE FORFEITURE OF THE GUARANTEE.
CE DECLARATION OF CONFORMITY:
The supplier: Monolith S.r.l. - Via dell’Artigiano, 8/F-8/G - 31050 Monastier di Treviso (TV) - ITALY
Tel. +39 0422 842157 - Fax +39 0422 708978 - E-mail: info@monolithsrl.com - www.monolithsrl.com
Declares under its sole responsibility that the faucet model ZEUS001
Complies with ROHS II 2011/65/EU and 2015/863/EU; 2014/35/EU; 2014/30/EU directives.
The person authorized to form the technical dossier is Mr. Basso Davide as Legal Representative of the company.
Monastier di Treviso, 05.04.19 BASSO DAVIDE
Tabla de contenidos
Manuales populares de Accesorios de cocina y baño de otras marcas
Alpha Bidet
Alpha Bidet Alpha One Manual de usuario
InSinkErator
InSinkErator H/HC3300 Manual de instalación
Clou
Clou Xo type 1 Manual de usuario
Kohler
Kohler Contra 26448T-4 Manual de usuario
Grohe
Grohe Bridgeford 20 158 Manual de usuario
Hans Grohe
Hans Grohe Croma Select S 180 Showerpipe EcoSmart... Manual de usuario