Mohawk USL-600 Guía

USL-6000 CYLINDER REPLACEMENT PROCEDURE:

FILE: USL-CYL.DOC

REVISION: 6/30/98

TOOLS NEEDED:

•CROW BAR

•C-CLAMP

•¼” ALLEN WRENCH

•11/16” WRENCH OR CRESENT WRENCH

•MALLET

•PAPER TOWELS OR RAGS

•-6 JIC CAP NUTS

1. RAISE LIFT MID TO FULL HEIGHT ABOVE 6TH OR 7TH LOCK POSITION.

2. LOWER LIFT ONTO MECHANICAL LOCKS (ON 6TH OR 7TH LOCK POSITION). SECURE

DOWN HANDLE AT POWER UNIT IN LOWERING POSITION. (SEE BELOW)

3. PLACE CLAMP AROUND SIDE SUPPORT ARMS AS SHOWN. ENSURE THAT CLAMP IS

SNUG.

4. DISCONNECT HYDRAULIC LINE AT BOTTOM OF CYLINDER ROD.

5. CAP VELOCITY FUSE AT END OF CYLINDER ROD LOOSELY.

6. REMOVE SET SCREW AT END OF CYLINDER ROD.

7. PLACE RAGS OR PAPER TOWELD UNDER ROD END ON FLOOR.

8. USE CROW BAR TO PRY PIN OUT OF END OF SUPPORT PLATE AT CYLINDER ROD END.

(A SOCKET MAY BE HELPFUL TO SHIM THE PIN OUT OF THE HOLE).

9. ONCE PIN IS PUSHED ASIDE, PRY END OF ROD OUT UNTIL PIN CLEARS SIDE PLATE.

WARNING: ROD END WILL TRY TO FLIP UP. KEEP FIRM GRIP ON ROD END

DURING THIS STEP. SEE PICTURE BELOW.

10. ONCE ROD IS FREE OF MAIN TUBE, PIVOT CYLINDER SO ROD IS POINTING UP. SEE

BELOW.

11. HOLD CYLINDER FIRMLY AND PRESS SIDE SUPPORT ARMS AWAY FROM CYLINDER

(ENSURE THAT C-CLAMP IS STILL SECURE). REMOVE CYLINDER. SEE BELOW.

12. INSTALL NEW CYLINDER BY REVERSING STEPS.

NOTE: NEW CLYINDER WILL HAVE RETRACTED ROD. WAIT UNTIL CYLINDER IS

PLACED BETWEEN SIDE SUPPORT ARMS. THEN PIVOT CYLINDER, LOOSED FITTING

ON END OF ROD. PULL OUT ROD TO SECURE ROD END PIN TO MAIN TUBE AT

BOTTOM OF LIFT. ALWAYS BLEED SYSTEM AFTER REPLACING/REPAIRING

CYLINDER.

-END OF DOCUMENT -

Tabla de contenidos

Otros manuales de Sistema de elevación de Mohawk

Mohawk

Mohawk TL-7 Manual de usuario

Mohawk

Mohawk ML-220 Manual de usuario

Mohawk

Mohawk TP-15 Manual de usuario

Mohawk

Mohawk A-7 Manual de usuario

Mohawk

Mohawk TP-20 Manual de usuario

Mohawk

Mohawk V-035-A-X Manual de usuario

Mohawk

Mohawk TR-25A Manual de usuario

Mohawk

Mohawk V-085-C-X Manual de usuario

Mohawk

Mohawk LMF-12 Manual de usuario

Mohawk

Mohawk TD-1000-AH Manual de usuario

Mohawk

Mohawk IA Manual de usuario

Mohawk

Mohawk MP-18-24VDC Series Manual de usuario

Mohawk

Mohawk TR-33 Manual de usuario

Mohawk

Mohawk TP-18 Manual de usuario

Mohawk

Mohawk TR-110 Manual de usuario

Manuales populares de Sistema de elevación de otras marcas

morse

morse 82H-124 Manual de usuario

Braun

Braun NL955 Series Manual de usuario

haacon

haacon 1889.10 Manual de usuario

Protekt

Protekt AT 252 Manual de usuario

R. Beck Maschinenbau

R. Beck Maschinenbau HS 600 Manual de usuario

Nova Technology International, LLC

Nova Technology International, LLC NAS Series Manual de usuario

Genie

Genie Z-60/34 Manual de usuario

Screen Technics

Screen Technics INTERFIT Vertical Up Lift Manual de usuario

Mortuary Lift

Mortuary Lift ULTIMATE 1000 Manual de usuario

Custom Equipment

Custom Equipment Hy-Brid 3 Series Manual de programación

Custom Equipment

Custom Equipment Hy-Brid Lifts 2 Series Manual de programación

Hy-Brid Lifts

Hy-Brid Lifts HB-P3.6 Manual de programación

BERG

BERG BeNomic EasyLeaf Manual de usuario

Powermate

Powermate LiftGate LG-3 Manual de usuario

Snorkel

Snorkel TM12 Series Manual de usuario

Terberg

Terberg OMNIDEKA Manual de usuario

Harmar Mobility

Harmar Mobility AL625 Instrucciones de funcionamiento

Rotary

Rotary SPO16 Manual de usuario