If you have any questions, please call MINCEY MARBLE CUSTOMER SERVICE at 1-800-533-1806.
Mincey Marble Mfg., Inc. |1940 New Harvest Road, Gainesville, GA 30507 |800.533.1806 |minceymarble.com
Next, you are going to prepare to install the Glass Door. First, you will install the ROLLERS onto the Glass Door.
The TOP ROLLERS have an Adjustment Screw that goes to the bottom, so that it can be adjusted from the
bottom. The BOTTOM ROLLERS WITH STUDS will be installed on the bottom of the Glass Door with the
collapsible plunger going to the top, to ensure that when properly adjusted, tension will help secure the door
in place.
On which side of the Glass Door you install the ROLLERS
depends on which side of the shower the door is located.
In these instructions, the door is on the Right, opening to
the Left. The Glass Door will be located on the Inside of
the shower and the Fixed Glass Panel will be located on the
Outside of the shower. Therefore, the ROLLERS will be
installed on the Outside of the Glass Door.
BRUNSWICK BOW FRONT ENCLOSURE SYSTEM INSTALLATION (cont.) 5
TOP ROLLERS ON THE GLASS DOOR
TO THE OUTSIDE OF THE SHOWER,
THE ADJUSTMENT SCREW GOES TO
THE BOTTOM FOR ACCESSIBILITY
BOTTOM ROLLERS ON THE GLASS DOOR
TO THE OUTSIDE OF THE SHOWER, THE
PLUNGER GOES TO THE TOP TO SECURE
THE DOOR WITH TENSION
When the Rollers have been installed, place the Glass Door inside the Shower. To install the Glass Door, TILT the
Door into the TRACK of the Top Header, PRESS the PLUNGERS on the Bottom Rollers and pop the door into the
TRACK of the Bottom Header.
<RXZLOOZDQWWRDGMXVWWKH%RWWRP6FUHZVRQWKH7RS5ROOHUVWRPDNHVXUHWKH*ODVV'RRU¿WV)OXVKZLWKWKH
Door Strike Wall Jamb. You do this by turning the Top Roller Screws - Clockwise to Lower the Door, and
Counter-Clockwise to Raise the Door. You will also want to Raise the Glass Door enough that there
is tension on the Bottom Roller Plunger to help secure the Glass Door in the Tracks. Make sure
the Glass Door closes securely against the Magnetic Strip of the Door Strike Wall Jamb when closed.
GLASS DOOR TO INSIDE
OF SHOWER,
FIXED GLASS PANEL TO
OUTSIDE OF SHOWER
GLASS DOOR ROLLERS TO
OUTSIDE OF SHOWER
TILT DOOR AND PLACE TOP ROLLERS
INTO THE TOP HEADER TRACK,
PRESS THE PLUNGERS ON THE BOTTOM
ROLLERS AND SNAP INTO BOTTOM TRACK
ADJUST THE TOP
ROLLER SCREWS
TO ALIGN THE
DOOR FLUSH
WITH THE
MAGNETIC STRIP
OF THE DOOR
STRIKE WALL
JAMB
CLOCKWISE TO LOWER
THE DOOR,
COUNTER-CLOCKWISE
TO RAISE THE DOOR
INSERT RUBBER
BUMPER FOR
THE GLASS INTO
DOOR STOP
SECURE DOOR STOPS TO HEADER
TO PROTECT THE DOOR FROM
FULL RANGE OF MOTION
