Millipore Samplicity Manual de usuario

1. With system handle in the OFF position,

attach quick disconnect end of tubing to

system and other end to vacuum source.

Place vial tray on system base with tray

numbers facing forward.

2. Place one to eight uncapped

12 x 32 mm vials in the vial

tray.

3. Place lid over vials. 4. Open doors directly above the

positions where vials have been

installed. Close doors above

empty positions.

1 2 3 4 5 6 7 8

1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8

5. Place one to eight Millex Samplicity

Filters over the openings, with the M

logos facing forward. Filters can be

separated from the strip by twisting

them at the perforations.

6. Add samples (0.2–1.7 mL)

to ﬁlters.

7. Turn vacuum on at the source,

then rotate system handle

forward. Vacuum will pull

samples through the ﬁlters and

into the vials.

8. When all ﬁlters are empty, rotate

the system handle up and wait for

the vacuum pressure to release.

Remove ﬁlters, then remove lid to

access sample vials.

Samplicity™ Filtration System with

Millex Samplicity™ Filters

Quick-Start Guide

Full length user guide is available at www.millipore.com. Search on key word "Samplicity ".

Before using the Samplicity Filtration System, please read the full length user guide completely.

PR03530_RevA.indd 1 3/14/2011 8:05:14 AM

Components Supplied

Components Needed

Millex Samplicity Filters for the Samplicity Filtration System

0.20 µm hydrophilic PTFE ﬁlter

0.45 µm hydrophilic PTFE ﬁlter

Vacuum source

Pipette and pipette tips

Sample vials (12 x 32 mm)

The M logo is a trademark of Merck KGaA, Darmstadt, Germany.

Millipore is a registered trademark of Millipore Corporation.

Samplicity and Millex Samplicity are trademarks of Millipore Corporation.

PR03530, Rev. A, 03/11

Operating Tips

■ Vacuum should remain off while system is being assembled.

■ Vacuum pressure of 18–25 inches Hg (610–847 millibar) is

recommended for optimum performance.

■ The waste tray can be used in place of vials when washing or

ﬂushing the ﬁlters prior to sample ﬁltration.

■ Doors above empty positions must be closed.

■ Do not turn on vacuum until after samples have been added to

ﬁlters.

■ Make sure that all samples have ﬁltered into vials before turning

vacuum off. Some samples may take longer to process.

■ System must be turned off (system handle UP) and pressure

allowed to release through the bleeder valve before removing

ﬁlters and lid, or opening doors. Cross-contamination may occur

if ﬁlters, lid, or doors are moved before vacuum pressure is fully

released.

Samplicity Filtration System

Lid

Vial tray

Filtration system

base

Waste tray

Tubing

PR03530_RevA.indd 2 3/14/2011 8:05:15 AM

Otros manuales de Equipo de laboratorio de Millipore

Millipore

Millipore APC ErgoTouch Pro 2 Manual de usuario

Millipore

Millipore Millicell ERS-2 Manual de usuario

Millipore

Millipore XX11 000 00 Manual de usuario

Millipore

Millipore PR00SIA1 Manual de uso y cuidado

Millipore

Millipore 8003 Manual de usuario

Millipore

Millipore Elix 35 Manual de usuario

Millipore

Millipore Amicon Ultra-4 Series Manual de usuario

Millipore

Millipore Labscale Manual de usuario

Millipore

Millipore Amicon 6028 Manual de usuario

Millipore

Millipore Millicell MDCI10000 Manual de usuario

Millipore

Millipore Amicon Ultra-2 Manual de usuario

Millipore

Millipore Milliflex Oasis Manual de usuario

Millipore

Millipore milli-q Manual de usuario

Millipore

Millipore Spectroquant Multy Manual de usuario

Millipore

Millipore XX4004700 Manual de usuario

Millipore

Millipore ReadyStream Manual de usuario

Millipore

Millipore Milli-Q Advantage A10 Manual de usuario

Millipore

Millipore SNAP i.d Manual de usuario

Millipore

Millipore Helicon S10 Manual de usuario

Millipore

Millipore M Air T Manual de usuario

Millipore

Millipore Direct Detect Manual de usuario

Millipore

Millipore Viresolve Pro VPMCPDKNB9 Manual de usuario

Millipore

Millipore MERCK EZ-Pak Manual de usuario

Millipore

Millipore Steritest Symbio Manual de usuario

Manuales populares de Equipo de laboratorio de otras marcas

Qiagen

Qiagen DML 3000 Manual de usuario

Queensgate

Queensgate NANOSCAN OP400 Manual de programación

Conviron

Conviron GEN1000-GE Manual de usuario

Parr Instrument

Parr Instrument 4560 Manual de instrucciones

IKA

IKA IC control Manual de usuario

Integra

Integra DOSE IT Manual de usuario

Agilent Technologies

Agilent Technologies 5800 ICP-OES Manual de usuario

Endress+Hauser

Endress+Hauser Cleanfit CPA875 Manual de usuario

NI PXI-5422 Manual

Collomix

Collomix Aqix Manual de usuario

SPEX SamplePrep

SPEX SamplePrep 6875 Freezer/Mill Series Manual de usuario

Ocean Insight

Ocean Insight FLAME-NIR+ Manual de usuario

Parker

Parker ALIGN-MG-NA Manual de usuario

BD 644787 Manual de usuario

DENTAURUM

DENTAURUM Compact Megaplus Manual de usuario

Biuged Laboratory Instruments

Biuged Laboratory Instruments BGD 626 Manual de usuario

VWR

VWR SAS Super IAQ Manual de usuario

illumina

illumina MiSeqDx Manual de usuario