Vertical Steam
Dry Ironing
Steam Ironing
Burst of Steam
3
Burst of Steam”can also be applied when holding the iron in vertical position,
this is useful for removing creases from hanging clothes, curtains, et.
1. Set the steam selector to position O(=No Steam)
2. As per washing label of various clothes, set the correct ironing
temperature to begin a ironing.
1. Fill water in the iron as per the water-lling methods.
2. Plug the appliance in the socket.
3. If only set thermostat knob to MAX position as per the temperature
indicator, steam iron will be available, otherwise water may leak from the
sole plate.
4. It indicates that the temperature has been ready until the indicator
light goes o.
5. Set the steam selector correctly, increase steam output by pushing the
steam selector back and decrease steam output by forward.
Caution: Synthetic Fabric, Nylon, Synthetic Silk and Silk cannot use the
steam iron, otherwise it will damage the nish of surface.
This function works well for tough wrinkles and heavy fabrics. By pressing
“Burst of Steam” button,an intense burst of steam is emitted from the
soleplate, this can be very useful when removing stubborn creases. The
shot of steam facility can be used only while ironing with high ironing
temperature. For optimal result, there should be 5 seconds rest between
presses of the steam button. To prevent leaking water from the soleplate
does not press the steam button continuously for more than 5 seconds..
Also allow at least one minute interval before applying this burst of steam
function.
Spraying Methods
Self-Cleaning
At any temperature by pressing the spray button a couple of times, the laundry
can be damped down. Ensure that there is enough water in the water tank.
Use the self-cleaning function once every two weeks. If the water in your area
is very hard(i.e, when akes come out of the soleplate during ironing),the self-
cleaning function should be used more frequently.). Make sure the appliance is
unplugged, set the steam selector to position“O”, ll the water tank to the MAX
position, do not put vinegar or other dealing agents in the water tank., select
the maximum ironing temperature, put the plug in the wall socket, unplug the
iron when the power indicator lighter has gone out, hold the iron over the sink,
press and hold the self-cleaning button and gently shake the iron to and fro.
