Wireless DA-606LK and DA-606LK2 Light Kits
FCC Infortmation:
These devices are approved by the FCC and they comply with part 15 of the FCC rules. Operation is subject to these conditions:
1. These devices may not cause harmful interference.
2. The devices must accept any interference that may cause undesired operation.
3. Modication of the devices may void the right to operate the devices.
SPECIFICATIONS: The DA-606 Remote Control Transmitter operates on 318 mHz
Range between DA-066 Remote Control Transmitter and the DA-071 Wall Switches, DA-072 Lamp
Modules, and/or DA-073 Outlets is about 500 feet in an open area
The DA-606 Remote Control Transmitter uses a CR2032 battery
The DA-071 Wall Switch’s minimum load is 10 watts and maximum load is 1000 watts at 120 VAC
The DA-072 Lamp Module’s minimum load is 10 watts and maximum load is 300 watts at 120 VAC
The DA-073 Heavy-Duty Outlet’s minimum load is 10 watts and maximum load is 1500 watts at 120 VAC
Device Programming (should only be done in rare circumstances when factory settings have been lost):
ERASING FACTORY PROGRAMMING COMMANDS: The Wall Switch must not be in lamp timing mode (lamps off). Turn
lamps on by pressing the Wall Switch button. Two blue LEDs will be off. Press the small red button on the back of the Remote
Control Transmitter for 2 seconds. Push the front button on the Remote Control and the set button on the Wall Switch at the same
time for 5 seconds.The upper blue LED will ash when erased, then both LEDs will ash. Turn lamp off with the Wall Switch and
press the front button on the Remote Control to conrm the lamp does not come on. The Wall Switch will now not respond to
Remote Commands.
To erase Lamp Module programming, remove the Lamp Module from the AC outlet. Press and hold the SET button while plugging
the Lamp Module back into the outlet. The RED LED will be on rst, then ash rapidly for about 1 second, then on then off. Now
release the SET button. The Lamp Module will not respond to Remote Control Commands.
PROGRAMMING THE WALL SWITCH:
The Wall Switch must have power applied. Both blue LEDs will be on. Turn switch and lamps on by pushing the wall switch but-
ton. Both blue LEDs will be off. Bring the Remote Control Transmitter near the Wall Switch. Press the SET button on the Wall
Switch until the upper blue LED is on steady. It will ash rst. Release the SET button. You must complete the following steps
within 15 seconds. Push the small RED button on the back of the Remote Control for 1 second, then push the front button for
about 3 seconds. The upper blue LED on the Wall Switch will ash and the bottom blue LED will be blinking. This indicates that
the Wall Switch is in 1 minute timing mode and lamps should turn off in 1 minute. The Wall Switch is now set to operate with the
Remote Control. To change the timing of the lamps, see the instructions above. The Remote Control Transmitter may now be
reconnected to the Drive-Alert control panel.
PROGRAMMING THE LAMP MODULE:
Plug a lamp into the Lamp Module socket. Plug the Lamp Module into a 120 VAC outlet. The RED light will ash once. The lamp
should be off. Press and hold the SET button on the Lamp Module for about 3 seconds, the RED LED will ash. Release the
SET button. Now press and hold the SET button in for about 10 seconds or until the RED LED is on steady. The next steps must
be done in 15 seconds. Press the small RED button on the back of the Remote Control for about 1 second, then press the front
button for about 3 seconds. The RED LED on the Lamp Module will ash then stop ashing. The Lamp Module should now be in
the 1 minute timing mode and should go off in 1 minute. To change the timing, see the instructions above.
