Miele G 6994 Manual de usuario
Quick Start Guide
for dishwashers
These short instructions are not a substitute for the
operating instructions supplied with the appliance.
Please read the operating instructions supplied with your
dishwasher before using it for the first time and take note of
the Warning and Safety instructions, as well as the full
descriptions on how to use your appliance.
en-AU, NZ
M.-Nr. 10 632 800 / 01
Guide to the appliance
aOn/Off sensor
For switching the dishwasher on and
off.
bTimeControl In-operation indicator
lights
For displaying the programme time
remaining with the door shut.
cInformation sensor
For displaying additional information
about the option in the display.
dArrow sensors
For selecting programmes, altering
values shown in the display and for
navigating between different menus.
eBack sensor
For navigating back to the previous
menu or deleting values which have
been set previously.
fOK sensor
For selecting the option shown in the
display.
For confirming messages.
gDisplay
See next page for more information.
hDelay start sensor with
indicator light
For selecting the "Delay start"
function.
Opening the door
This dishwasher has a motorised door opener which is activated by knocking on
the door front ("Knock2open function").
Knock twice in quick succession on the top third of the door front.
The door will open a little.
Brief instructions
Filling the salt reservoir
When filling the salt reservoir only
open the door halfway to ensure
that all the salt gets into the reservoir.
Press the button on the lid of the salt
reservoir in the direction of the arrow
until the flap springs open.
Lift up the funnel.
Dishwasher detergent will
damage the water softener.
Do not fill the salt reservoir with
powder or liquid detergent.
Do not fill the reservoir with water.
Add dishwasher salt only until the
reservoir is full or until water runs out
of the opening.
Clean any excess salt from around
the reservoir opening and then close
the flap.
Immediately after filling the salt
reservoir, run the QuickPowerWash
programme with the Short
programme option selected and
without any crockery in the
dishwasher to remove any traces of
salt from the cabinet.
Adding rinse aid
Press the button on the lid of the
rinse aid reservoir in the direction of
the arrow until the flap springs open.
Add rinse aid only until it is visible in
the opening.
Close the flap firmly. It should click
into place.
Wipe up any spilled rinse aid. This
prevents over-foaming occurring
during the next programme.
Load the dishwasher
Adding detergent
Follow the dosage recommended by
the manufacturer on the packaging.
Press the opening catch on the
detergent dispenser. The flap will
spring open.
The flap is always open at the end of a
programme.
Add the required amount of detergent
and close the flap.
Switching on the dishwasher
Turn on the tap if it is turned off.
Open the door.
Switch the dishwasher on using the
button.
The main menu will appear in the
display.
If the Memory function is selected, the
last programme selected will appear in
the display instead of the main menu.
Selecting a programme
Use the arrows to select the
programme required.
The display will change to show the
programme menu.
Selecting Extras (if required)
Select the Extras option.
All available Extras will be shown in the
display.
Select the Extras you want using the
OK button.
A tick will appear beside the Extra to
show that it has been selected.
To deselect an Extra you have
chosen, simply press the OK button
again.
When you have finished selecting
Extras, confirm with Accept.
The display will change back to the
programme menu.
The number of Extras selected will
appear in the programme menu.
Activating Delay start (if required)
Press the button.
Select the function you want.
Use the arrow buttons to set the
time and confirm with OK.
The display will change to show the
programme menu.
Starting the programme
Start the programme by closing the
door.
At the end of a programme -
Switching off
At the end of a programme, the
TimeControl indicator light will go out
with the door shut.
The buzzer might also be sounding.
The programme has finished when
Finished appears in the display and the
door has opened slightly (if applicable).
In the QuickPowerWash programme the
door will not open until a few minutes
after the programme has finished.
The drying fan may continue to run for
a few minutes at the end of the
programme.
Switch the dishwasher off using the
button.
If you have deactivated the
automatic door opening function but
would still like to open the door at
the end of the programme, then
make sure that you open the door
fully.
Otherwise steam from the
dishwasher could damage the edge
of the worktop because the fan is no
longer running.
Unloading the dishwasher
Dishes tend to break and chip more
easily when they are hot. Allow the
dishes to cool until they are comfortable
enough to handle before unloading
them.
Cleaning and care
Checking the filters in the
wash cabinet
This dishwasher must not be
used without all the filters in place.
The message Check filters will appear in
the display after every 50 programme
cycles (factory default setting).
Check the condition of the filters
regularly and clean them if necessary.
Then confirm the message with OK.
Cleaning the filters
Switch the dishwasher off.
Turn the handle anti-clockwise to
release the filter combination .
Lift the filter combination out of the
dishwasher . Remove any coarse
particles and rinse the filter well
under running water.
Use a nylon brush if necessary.
Ensure that course soil doesn't
get into the circulation system and
cause a blockage.
To clean the inside of the filter, the flap
must be opened:
Press catches together in the
direction of the arrows as shown, and
open the filter .
Rinse all the filters under running
water.
Then close the flap so that the catch
engages.
Replace the filter combination so that
it lies flat in the base of the wash
cabinet.
Then turn the handle clockwise until
both arrows point towards each
other. This will lock the filter
combination in place.
Cleaning the spray arms
Particles of food can get stuck in the
spray arm jets and bearings. The spray
arms should therefore be inspected and
cleaned regularly (approx. every 4 - 6
months).
Switch the dishwasher off.
Remove the spray arms as follows:
Take out the cutlery tray (if your
dishwasher is fitted with one).
Push the top spray arm upwards to
engage the inner ratchet. Then
unscrew the spray arm.
Push the middle spray arm upwards
to engage the ratchet. Then
unscrew the spray arm .
Remove the lower basket.
Pull the lower spray arm firmly
upwards to remove it.
Use a pointed object to push food
particles into the spray arm jets.
Rinse thoroughly under running
water.
Refit the spray arms and check that
they rotate freely.
Programme chart
Mixed,
everyday crockery
Heat-sensitive glasses and
plastic
Mixed crockery
Pots, pans, everyday porcelain
and cutlery
No crockery
All fresh to dried-on food
deposits
Fresh, easily removed food
deposits
Normal food deposits which
have begun to dry on
Burnt-on, stubborn, dried-
on food deposits containing
starch or protein 1)
Residual salt after refilling the
salt container
Variable, sensor-controlled
programme sequence
Shorter duration
Short programme with
duration less than 1 hour 3)
Gentle programme with
glass care
Shorter duration
Very quiet programme
Water and
energy saving programme
Shorter duration
Average programme values
Shorter duration
Maximum cleaning power
Shorter duration
Flushes out salt residues
1) Food such as potatoes, pasta, rice or stews can leave starchy deposits. Deposits containing protein
can be left by food such as meat, fish or eggs and bakes.
Crockery Food deposits Programme
features
Fresh food deposits which
have begun to dry on
Fresh food deposits which
have begun to dry on
-
25 ml
or
1 tab
Automatic
+short
- 1 tab 3)
QuickPowerWash
-
20 ml
or
1 tab
Gentle
+short
-
25 ml
or
1 tab
ExtraQuiet
-
25 ml
or
1 tab
ECO
+short
-
25 ml
or
1 tab
Light soiling 55°C
+short
10 ml
25 ml
or
1 tab
Intensive 75°C
+short
- -
QuickPowerWash
+short
2) see "Detergent"
3) best cleaning results are only achieved with Miele's quick dissolving UltraTab Multi
Detergent
Compartment I 2) Compartment II 2)
Programme
Otros manuales para G 6994
1
Tabla de contenidos
Otros manuales de Lavavajillas de Miele
Miele
Miele G 542 U Manual de usuario
Miele
Miele G 6575 Manual de usuario
Miele
Miele Classic G 4275 SCVi Manual de lista de piezas
Miele
Miele G 811 Manual de usuario
Miele
Miele G 863 Plus Manual de usuario
Miele
Miele for dishwashers Manual de usuario
Miele
Miele PG 8080 U Manual de usuario
Miele
Miele G4500SCI Manual de lista de piezas
Miele
Miele Standard Manual de usuario
Miele
Miele G 1182 Manual de usuario
Miele
Miele G 1000 Manual de usuario
Miele
Miele PFD 104 SCVi Manual de usuario
Miele
Miele G 7859 Manual de usuario
Miele
Miele G 7154 Manual de usuario
Miele
Miele Dishwasher Manual de usuario
Miele
Miele tx2349 Manual de usuario
Miele
Miele G 15640-45 SCi SL Guía
Miele
Miele G 5110 Manual de usuario
Miele
Miele G 818 Manual de usuario
Miele
Miele G 7966 Manual de usuario
